782670
5
Zoom out
Zoom in
Previous page
1/10
Next page
Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483
English
Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator 5
PLUMBING
EccoFlo recommends at least 1 ft (.3m) of 1/2” (13mm) I.D. exible high pressure tubing to
both ports. Ideally the pump’s ports/strainer should not be connected to plastic or rigid
pipe. The pump’s normal oscillation may transmit through rigid plumbing causing noise, and
possibly loosen or crack components.
Installation of the 50-mesh strainer such as is recommended to prevent foreign debris from
entering the pump. EccoFlo hex/swivel barb ttings provide easy removal if maintenance
or access is required. The ttings are designed with a “taper-seal”, creating a water tight
connection when hand-tightened. Always secure barb tubing connections with properly sized
stainless steel clamps to prevent leaks. Never use plumbers tape or sealing compounds on
threads. Sealer may enter the pumps causing a failure. Failure due to foreign debris is not
covered under warranty.
Rapid cycling may be caused by excessive back pressure created by one or more of the
following within a plumbing system: Water lters and puriers not on separate feed lines,
ow restrictors in faucets and shower heads, small ID lines pipe/tubing should be at least
1/2” (13mm) for main lines, restrictive ttings and connections (elbows, “T”s, feeder lines to
faucets, etc.) The pump with by-pass do not need to use pressure tank. If the pump is cycling
rapidly increase the setting by turning the screw clockwise (1 ½ turn max) until the pump
operates for 1 sec. with at least 2 sec.” OFF time”.
The pump’s duty cycle is: intermittently. Do not use the pump under anti-osmosis ltering
systems. Continuous running under higher pressure may reduce pump life and it is not under
the warranty.
OPERATION
(This pump is designed for intermittent duty only.)
The pump operates normally up to about 40-psi, where a spring-loaded by-pass valve opens,
allowing ow back from the output side to the input side, providing smooth, steady ow with
virtually no cycling, all the way down to a trickle. As a faucet is opened back up, the pressure
will drop, the by-pass will close and full ow is again obtained. This allows good ow, even
with today’s restrictive showers and pullout sprayer faucets. Performance will vary, of course,
depending on the voltage to the pump; lower voltage = lower ow, higher voltage = higher
ow. Remember your electrical safety: It is always best to shut o power to the pump OFF
when leaving the RV unattended.
About the by-pass NOTE: By-pass adjustment should be performed by professional
technicians with proper gauge and equipment.
The by-pass is a spring loaded diaphragm that opens up allowing water from the discharge
side back to the inlet side. The by-pass is set to begin opening at about 40psi and increasing
full by-pass at about 62 psi. The pressure switch on the pump is set to shut o at 55 psi. If the
switch or by-pass is adjusted too much, the by-pass and switch shut-o pressure. Unscrewing
the switch screw counterclockwise will lower the pump shut-o pressure. Screwing the by-pass
screw in will raise the pressure at which the by-pass starts and lower the full by-pass pressure.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eccotemp EccoFlo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eccotemp EccoFlo in the language / languages: English as an attachment in your email.

The manual is 5.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Eccotemp EccoFlo

Eccotemp EccoFlo User Manual - German - 10 pages

Eccotemp EccoFlo User Manual - Dutch - 10 pages

Eccotemp EccoFlo User Manual - French - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info