611863
7
Zoom out
Zoom in
Previous page
1/24
Next page
Receiver - Plug-In Dimmer Module Ref : RPL
July 2009 page 7 RPL
To reset all lamp module addresses
1. Use a small sharp object, e.g. a paper clip, to press and hold the
setup button until the green led turns on. (about 3 or 4 seconds)
2. Release the button, the led will blink red and green and then
turn off.
3. When the red and green LEDs are off, the module is reset.
Tips - Knowledge base available on www.ebodeelectronics.eu.
Can I plug RPL module into a power strip?
This is no problem with a simple power strip however you can not use the module
with a surge protected power strip.
Operating the RPL Module
I’m using a X10 compatible wireless remote, e.g. TPC, IMRF, EM, SS13,
KR22, SH600 or HR10, but the RPL is not responding?
- Check and/or change remote control batteries.
- Check if your transceiver is correctly connected.
RF Transmitter = RPT, RMA, RMV, TM13, CM15 or SC28 security console
IR Transmitter = IR7243 along with the remote control
- Reset the RPL (see paragraph 3) then reprogram the address.
- Then, proceed again using learning mode as explained in 2.)
The RPT does not respond to command sent via the power line?
- Reset the RPL (see paragraph 3) then initialize the address.
- Then, proceed again using learning mode as explained in 2.
Functions enabled by a wireless transmitter (EM, TPC, IMRF, etc..)
ON / OFF key
Turns the lamp On & Off
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ebode RPL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ebode RPL in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish, Norwegian as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info