RADIO
ATTACHING AERIAL
If you use the wire aerial for FM reception:
• The wire must be fully wound out
• Determine the best position by trial and error
• Attach the wire aerial to the wall if necessary using a strip of adhesive tape.
For MW reception, place the device in the best position for the in-built aerial, again by trial and error.
OPERATING THE RADIO/ SELECT BAND (FM/MW)
01) Select * TUNER (=Radio) using the device selector button.
02) Select between FM (VHF) and AM (medium wave) using the BAND SELECTOR button
_.
AUTOMATIC STATION SEARCH / MANUAL SEARCH
In an automatic search the frequency is increased or deceased until a station of adequate reception strength is found.
01) Hold down the 8 UP/Forward button ) or 7 DOWN/Reverse button 8 for about 1 second – the search starts and stops automatically.
02) To start the search again, hold down the 8 UP/Forward button ) or 7 DOWN/Reverse button 8 again for about 1 second.
You can use the manual station search for fine adjustment or when the frequency of the station is known.
01) Press the
8 UP/Forward button ) or 7 DOWN/Reverse button 8 briefly to increase or decrease the frequency in small steps.
02) Keep the 8 UP/Forward button ) or 7 DOWN/Reverse button 8 pressed until you are close to the frequency you require.
STORE STATION
[ » MEMORY « ]
The Designer Audio Unit KH 2310/20/30 can store up to 20 stations (10 FM / 10 AM).
01) You set up the desired station by following the instructions relating to "Automatic station search/manual station search"
described above.
02) Press the MEMORY/CLK-ADJ button
\ once. Next the station number shows for 5 seconds on the left side of the display @.
You must carry out the next step within those 5 seconds, otherwise the device switches itself into normal display. If this happens,
press the MEMORY/CLK-ADJ button
\ again.
03) Press the M-UP/REPEAT button = repeatedly until the required station number (1 to 10) is displayed.
Repeat this procedure for all the other stations you require have been stored.
SELECT STORED STATION
Press the M-UP/REPEAT button = repeatedly until the required station number (1 to 10) for the stored station is displayed @.
CD PLAYER
DANGER! The CD player uses a weak but sharply focussed laser beam to scan the surface of the CD. If the device is used improperly
then this light can be dangerous to the eyes - never open the case.
INSERTING A CD
01) To open the CD compartment ! pull the top edge towards the front.
02) Insert the CD with the playing side facing towards the device. If you have done this correctly, you should be looking at the
printed side. The CD must be placed securely on the central pin.
03) Close CD compartment
!.
04) Select the CD player with the device selector button * CD. The display @ shows the total playing time and the number of tracks.
NOTE: When you insert a CD, if the display does not show the number of tracks and the total playing time then the CD is possibly
the wrong way round or dirty. Clean the CD with a CD cleaning cloth or insert the CD correctly and check the display again.
INTRO FUNCTION [ " INTRO " ]
Activating the Intro function can only be done when the CD has stopped. Press the INTRO button 0 – each title on the inserted CD
is played for 10 seconds.
7