515345
21
Zoom out
Zoom in
Previous page
1/32
Next page
21
Programming acknowledged Successful remote programming of a calling number or calling number sequence
Programming, abort Faulty remote programming of a calling number or calling number sequence
Sensor n activated Announcement if sensor n is still in alarm mode
Supervision (I/II/III) < due to
noise / sensor n> activated
Confirmation of DTMF 5 : announcement of the activated supervision functions,
indicating the supervision modes in accordance to the position of the selection
switch (I/II/III)
Supervision (I/II/III) activated
Confirmation of DTMF 9 : Switch to active supervision mode an announce
monitoring functions at current position of the selection switch (I/II/III)
Supervision (I/II/III) deactivated
Confirmation of DTMF 7 : Switch to inactive supervision mode an announce
monitoring functions at current position of the selection switch (I/II/III)
Unacknowledged alarms: n Quantity of unacknowledged alarms
8.3 Functional checks
8.3.1 Test-call
We strongly advise to make a test-call to check functionality of EasyAlarm® before starting operation.
8.3.2 Test alarm functions
Even though the alarm unit is maintenance free (except the battery) a periodical function test should be carried out,
especially:
Emergency button
Wired sensors
Acoustical monitoring
8.4 Battery check / replacement
If the announcement „Battery error“ is initiated after switching on EasyAlar, the battery should be replaced
immediately as follows:
1. Slide function switch to OFF
2. Disconnect EasyAlarm® from the telephone network, by removing the telephone cord
3. Open battery compartment and remove old battery
4. Insert new battery and close battery compartment
5. Reconnect telephone cord to EasyAlarm®
Notes:
Always use fresh 9V-batteries
Dispose the old battery properly
8.5 Maintenance
Slide function switch to OFF and remove telephone cord. Clean EasyAlarm® if necessary using a moistened cloth and dry
it afterwards.
Note:
Do not use cleaning agents or solvent
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EasyAlarm CONTROL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EasyAlarm CONTROL in the language / languages: English as an attachment in your email.

The manual is 0,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of EasyAlarm CONTROL

EasyAlarm CONTROL User Manual - German - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info