667482
47
Zoom out
Zoom in
Previous page
1/58
Next page
42
XTL
®
300
User Guide
Cleaning the Sensors
Several sensors inside the label
compartment need periodic cleaning to
remove dust and other particles that may
have accumulated.
To clean the sensors
1 Press the label compartment release
and lift the cover.
2 Remove the label cartridge.
3 Remove the cleaning tool from inside
the label compartment cover.
4 Use the sponge end of the cleaning
tool to gently wipe the sensors using
an up and down motion (not side to side). See Figure 12 for sensor locations.
Cleaning the Cutter Blade
Clean the cutter blade each time you replace the label cartridge.
To clean the cutter blade
1 Press the label compartment release
and lift the cover.
2 Remove the label cartridge.
3 Insert a straightened paper clip (or
other pointed object) in the small hole
shown in Figure 13 to release the
cutter mechanism.
4 While pressing the paper clip down,
pull the cutter mechanism straight
out from the side of the label maker.
5 Place the cutter blade on a flat
surface with the blade side facing up.
6 Use a cotton swab and alcohol to
clean both sides of the blade. See
Figure 14.
The cutter blade is extremely sharp.
Use caution when cleaning.
7 After cleaning the blade, insert the
cutter mechanism back into the label
maker and press into place.
Sensors
Figure 12
Figure 13
Pull straight
out
Press and hold
Cutter blades
Figure 14
47


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dymo XTL300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dymo XTL300 in the language / languages: English as an attachment in your email.

The manual is 12,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dymo XTL300

Dymo XTL300 Quick start guide - English - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info