725662

Dutch Originals DO-CH-ACON120 Manual

14
Zoom out
Zoom in
Previous page
1/74
Next page
EN 12
on the digital control panel lights up.
Timer setting
The timer settings can be set from 1 hour to 24 hours.
There are 2 timer modes, to turn the device OFF and to turn it ON.
Timer turn OFF (when power is ON)
• Press the TIMER button on the device
2
or remote control
D
until the display
8
on the
digital control panel lights up 00.
• To set the timer delay OFF, press the increase
6
or decrease
7
button on the device or
press the increase
B
or decrease
C
button on the remote control. Each press increases
or decreases by one hour. The selected time is indicated on the display
8
.
Timer turn ON (when power is OFF)
• Press the TIMER button on the device
2
or remote control
D
until the the display
8
on
the digital control panel lights up 00.
• To set the timer delay OFF, press the increase
6
or decrease
7
button on the device or
press the increase
B
or decrease
C
button on the remote control. Each press increases
or decreases by one hour. The selected time is indicated on the display
8
.
Cancelling the set timer
To cancel the timer, press the increase
6
or decrease
7
button on the device or press the
increase
B
or decrease
C
button on the remote control, until OO shows on the display
8
.
Automatic defrost
At a low room temperature, frost may build up at the evaporator during operation.
The device automatically starts defrosting, the POWER LED
1
starts blinking.
When the device is in cooling, smart (can be cooling in smart mode) or dehumidifying
mode, the ambient temperature sensor senses the evaporator coil temperature. When this
temperature is below -1°C, the compressor stops operating. Approximately 10 minutes
later, or when the coil temperature is ≥ 7°C, the device starts to cool again.
Overload protection
In the event of a power loss or cut, there is a 3-minute delay until the compressor restarts.
Self-evaporating system
The self-evaporating system uses the collected water to cool the condenser coils for a
more efcient performance. There is no need to empty the water tank in cooling operation.
The condensated water will be evacuated via the air exhaust
7
and its connected exhaust
hose
A
.
The device requires ventilation to the outside, so that the (hot) exhaust air and moisture
can be dispelled outside the room that is being cooled.
Drainage
For continuous or unattended operation, connect the drain hose
E
to the drain opening
9
outlet of the device.
In this way condensate water can ow into a bucket or drain (by gravity).
… 14 …


Need help? Post your question in this forum.

Forumrules
1

Forum

dutch-originals-do-ch-acon120

Reset search

  • I am using this product and its brand new but it is giving a constant loud noise when switched on. How to fix this irritating noise? Thanks Submitted on 21-2-2022 at 16:23

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dutch Originals DO-CH-ACON120 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dutch Originals DO-CH-ACON120 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 11,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info