Dutch Originals DO-CE-WL02-W - DIGITAL SUNRISE ALARM CLOCK II Manual
4
Zoom out
Zoom in
Previous page
1/28
Next page
4EN
MODES
The device is equipped with dierent modes.
To select the dierent modes, press the power/mode button (12).
Modes: Time mode -> Natural sounds -> BT -> FM -> Time mode…
NATURAL SOUNDS
When the device is powered ON and in time mode, press the power/mode button (12) once to select the natural sounds mode.
(Modes: Time mode -> Natural sounds -> BT -> FM -> Time mode…)
On the display (9) the ‘NS’ icon will light up. Press and hold the volume up/next track (13) or volume down/previous track button (15) to select one of the 7 natural
sounds: 1. Singing birds -> 2. Jungle -> 3. Valley -> 4. Wind -> 5. Water creek -> 6. Rain -> 7. Beep ->
WIRELESS BT
When the device is powered ON and in time mode, press power/mode button (12) two times to enable the BT mode.
(Modes: Time mode -> Natural sounds -> BT -> FM -> Time mode…)
In BT mode you can connect your smartphone or tablet to stream music or to answer phone calls handsfree. A tone will sound and, on the display (9)‘BT’ icon
will flash quickly.
To set up a wireless BT connection go to “Making a BT connection (BT pairing)”.
FM RADIO
When the device is powered ON and in time mode, press power/mode button (12) three times to switch to the FM radio mode.
(Modes: Time mode -> Natural sounds -> BT -> FM -> Time mode…)
On the display (9) the ‘FM’ icon will light up.
Press the play/pause/call button (14) for ± 3 seconds to start the FM radio auto search mode.
The found radio stations will automatically be stored under the pre-sets.
Press the play/pause/call button (14) to stop the auto searching and return to the 1st stored pre-set.
Press and hold the volume up/next track (13) or volume down/previous track button (15) to select one of the stored FM pre-sets. On the display (9) will be shown
‘CH xx’ (xx stands for the number of FM pre-set).
VOLUME SETTING
• To increase the volume, press the volume up/next track button (13).
Once the maximum volume has been reached, a tone will sound.
• To decrease the volume, press the volume down/previous track button (15).
On the display (9) the volume setting will be shown as ‘U xx’ (xx stands for the volume level, 00 to 16).
SETTING THE ALARM WITH NATURAL SOUND ALARM
To set an alarm with one of the 7 natural sounds, press the alarm 1 button (2) for ± 2 seconds. The ‘alarm 1’ icon will light up and the hours & minutes digits will
flash on the display (9) indicating the set alarm time.
ADJUSTING THE SET ALARM
To set the alarm time, press the alarm 1 button (2) until the hour numbers start flashing on the display (9). To change the hour, press the – (3) or + button (5).
Press the alarm 1 button (2) again and the minute numbers start flashing. To change the minutes, press the – (3) or + button (5).
You can check the set alarm time by pressing the alarm 1 button (2), the hour numbers will flash, and after ± 10 seconds will return to last set mode.
SETTING THE DESIRED NATURAL SOUND
Press the alarm 1 button (2) three times to set the desired natural sound. Press the – (3) or + button (5) to select the desired natural sound
(1. Singing birds -> 2. Jungle -> 3. Valley -> 4. Wind -> 5. Water creek -> 6. Rain -> 7. Beep ->). The display (9) will show ‘A xx’ (xx stands for the number of selected
natural sound). Confirm the set natural sound by pressing the alarm 1 button(2).
SUNRISE
When the alarm is enabled, the device will start 30 minutes before the set alarm by gradually lighting up to a maximum brightness at the set alarm.
When the alarm goes o, the light is at maximum brightness and the natural sound will be heard.
Note! In case the set alarm is set less than 30 minutes before the actual time, the lighting up function will not be enabled.
To cancel the alarm, press the alarm 1 button (2) for ± 2 seconds. The light and natural sound will switch OFF. The ‘alarm 1’ icon will no longer light up on the
display (9).
SETTING THE ALARM WITH FM RADIO ALARM
To set an alarm with FM radio, press the alarm 2 button (6) for ± 2 seconds. The ‘alarm 2’ icon will light up and the hours & minutes digits will flash on the display
(9) indicating the set alarm time.
ADJUSTING THE SET ALARM
To set the alarm time, press the alarm 2 button (6) until the hour numbers start flashing on the display (9). To change the hour, press the – (3) or + button (5).
Press the alarm 2 button (6) again and the minute numbers start flashing. To change the minutes, press the – (3) or + button (5).
You can check the set alarm time by pressing the alarm 2 button (6), the hour numbers will flash, and after ± 10 seconds will return to last set mode.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Dutch Originals DO-CE-WL02-W - DIGITAL SUNRISE ALARM CLOCK II at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Dutch Originals DO-CE-WL02-W - DIGITAL SUNRISE ALARM CLOCK II in the language / languages: English, German, Dutch, French as an attachment in your email.
The manual is 3.74 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
