650115
10
Zoom out
Zoom in
Previous page
1/36
Next page
18 19
Operation
R e p l a c i n g t h e l a m p t u b e s
1. Switching on the lamp
Press the ON/OFF button on the upper edge of the lamp to switch on the
“Daylight.
Note
The brightness of the tubes may be visibly different when switched on. The
tubes develop their full luminosity after a couple of minutes.
2. Taking the light
Now sit down in front of the light or as close to it as comfortable, between 20
cm and 50 cm. You can go about your normal activities while using it. You can
read, write, make telephone calls, etc.
When using the lamp, try to maintain the recommended distance of 20 - 50
cm between your face and the lamp.
Usage guidelines are as follows:
In effect, the closer you are to the source of light, the less time you need to
use it.
Note
- Do not look directly into the light continuously! Some eye pain or mild
headaches may be experienced during initial sessions but these should pass.
If in doubt just lower your treatment times until comfortable again.
- Do not leave the appliance unattended in the duration.
- Do not touch the device in the duration. Let the device cool down for at least
Distance Duration of light therapy
60cm Approx. 2 hours
40cm Approx. 60 minutes
20cm Approx. 30 minutes
10 minutes before reposition it.
- Do not block vent holes in the duration.
3. Enjoying light over longer periods
During the darkest part of the year, repeat the treatment for at least 7
consecutive days, or for longer, depending on your individual requirements.
4. Switching off the “Daylight”
Press the ON/OFF button on the upper edge of the lamp to switch off the
“Daylight”. Pull the mains plug from the socket.
Note
- Lettheappliancecooldownrstbeforestoringitaway.
Replacing the lamp:
In the event that the lights are faulty, or when they come to end of their life, the
two light tubes can be replaced. NOTE: Do not replace the lamp tubes which
are not provided by the supplier. To do so, proceed as follows:
Warning
- Always unplug the “Daylight” and let it cool off.
- For safety reasons, do not remove any components or screws other than
thosespeciedbelow.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Duronic SADV1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Duronic SADV1 in the language / languages: English, German, French as an attachment in your email.

The manual is 1,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info