457853
66
Zoom out
Zoom in
Previous page
1/69
Next page
3.2 Direct sewing drive
3.2.1 Setting the reference
Caution: Risk of injury!
Switch the main switch off.
Check and adjust the hook setting only with the sewing unit switched
off.
Standard
When the needle is in the position “7 mm after the bottom dead
centre”, the drive belt has to be put on in such a way that the feather
key 2 in the motor shaft points to the marking 1 in the motor casing.
Correction
Remove the toothed belt.
Move the needle bar in the position “7 mm after the bottom dead
centre” by handwheel.
Turn the motor shaft in such a way that the feather key 2 in the
motor shaft points to the marking 1 in the motor casing.
Put the toothed belt on again.
7 mm
bottom dead centre
20
1
66


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler Beisler 1220-5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler Beisler 1220-5 in the language / languages: English as an attachment in your email.

The manual is 2,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info