612049
19
Zoom out
Zoom in
Previous page
1/36
Next page
5.14 Welting
The rapid-adjustment welt-guide mechanism with three positions is used to sew welts
between two layers of material. It can be swivelled in or out at the beginning and end of
the seam.
Four welt guides 2 are available (sewing attachments E20 - E23) with welt grooves from
3 to 6 mm.
Caution: danger of injury
Turn off the main switch.
The welt may only be inserted with the sewing machine
switched off.
Inserting the welt
Undo screw 1.
Feed welt in through welt guide 2.
Adjust welt guide 2 to the width of the welt.
The welt must be guided at the sides, but at the same time it must be easy to pull it
through the welt guide 2.
Tighten screw 1.
Sewing in the welt
Lay the welt between the two layers of material.
Pull out ball handle 4 and turn lever 3 as far as it will go to the left (position
P
).
Start sewing until the needle has reached approximately the middle of the welt.
To continue sewing in the welt pull out ball handle 4 and turn lever 3 to the centre
position (position
S
), where it engages.
At the end of the seam pull out ball handle 4 and turn lever 3 to its basic position
(position
0
).
3
4
1
2
21
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler b69 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler b69 in the language / languages: English as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info