612070
55
Zoom out
Zoom in
Previous page
1/68
Next page
6.2 Setting of machine positioning
6.2.1 Position definition
Position 1
The needle is down at the stopping in the seam. The angle 225° is on
the hand wheel scale.
Position 2
The needle is up after trimming. The angle 55° is on the hand wheel
scale using the VD552KV drive, and 45° using the DC1600 and
DC1550 motor drives.
The 1A and 2A positions are important only for the internal functions of
the DA82GA and DA321G controls.
6.2.2 Setting the machine positioning for DC1600/DA82GA motor drive and DC1550/DA321G
For the needle and other elements positioning the incremental sensor
located on the hand wheel is applied which gives 512 impulses
(increments) and one additional impulse per rotation. In general, the
particular position is defined by the number of increments between this
position and the reference position. The increment number is set by
the corresponding parameter value (it is not, however, identical with
the parameter value). The position parameter values have already
been set - see chapter 6.1.3.1. The reference position still remains to
be set.
The reference position is defined by the angle 105° on the hand wheel
scale.
After dismantling, mounting, or replacement of the synchronizer a new
reference position must be set.
See the “Efka DA82GA” or “Efka DA321G” operating manual.
23
GB
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler 887 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler 887 in the language / languages: English as an attachment in your email.

The manual is 1,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Durkopp Adler 887

Durkopp Adler 887 User Manual - German - 70 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info