4 Ring bolt
The ring bolt helps you to lift the automat into the stand. For example
you can hoist the automat by a ceiling crane or you put a rigid bar
(e.g. the bar of the thread stand) through the ring bolt and lift the
automat with 2 persons. The ring bolt is included in the accessories.
–
Screw the ring bolt 8 on the automat.
–
Lift the automat into the stand.
–
Screw off the ring bolt 8 when the automat is mounted.
5 Assembly of the main switch
–
Loosen the screw 4 and remove the switching knob 5.
–
Remove the main switch cover.
For this purpose, unlock the tab in the hole 6.
–
Insert the cable from the control box in the main switch.
–
Connect the cable cores of the control box to the terminals
L1 (1à brown) and L2 (2 à blue).
Connect the protective earth (3 à yellow-green) of the control box
to the main switch too.
–
Make sure that the notch 7 of the main switch faces down.
–
Put the main switch cover again. Put on the switching knob 5 and
screw it tight.
Hint
If you manufacture the table top yourself, fit the main switch at
an easily accessible place because the main switch is also the
emergency stop switch.
5
8
5
4
1
2
6
7
3