633982
37
Zoom out
Zoom in
Previous page
1/48
Next page
2-11
3.5.1 Presser foot
(max)
30V
15 V
120
00150
[ms]
SETUP-03
1. Position the cursor on the time of maximum power (left value in lower row)
and press the Plus/Minus key until 150 ms is set. This assures that the
presser foot is lifted safely after seam end.
2. Position the cursor on the value of the holding voltage (upper row, value in
the middle of the display) and press the Plus/Minus key until 15 V is set.
This assures that the magnetic valve for the foot release will not be
overloaded.
3. Position the cursor on the value of the start delay (right edge) and enter
120 ms here. This time is required to assure that the sewing foot rests
safely on the cloth before sewing starts.
4. Position the cursor on both presser foot icons and set them to „Presser
foot up“ like shown in the picture.
5. Press the Special key to leave this page.
6. Check, whether the presser foot is programmed on „up“ on page „PROG
000“, too.
3.5.5 Step motor transportation unit
The motor of the transportation unit is optimized as a factory setting and
should not be modified. Open the corresponding setup page to check the
settings:
SETUP-03
1234
080
2
8
1
6
107
1
8
8
1
80
8
8
8
1
10
JS
KJ
KP
KA
IL
IH
80
8
8
8
1
10
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler 1281-4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler 1281-4 in the language / languages: English as an attachment in your email.

The manual is 0,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Durkopp Adler 1281-4

Durkopp Adler 1281-4 User Manual - German - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info