499395
16
Zoom out
Zoom in
Previous page
1/21
Next page
16
FIG. 8
Polystyrene pad
FIG 7
By the strake you recognize a formed groove by the
front long side.
Into this groove you put the front base screen with the
shorter long side. At the upper long side the base
screen "is slid" into a groove in the front side member.
For this you press successively at several places, like
in Fig. 7 shown, the base screen somewhat to the rear.
Here the base screen slides itself in such a way
somewhat to curve and into the upper groove.
ABB. 9
For the assembly of the canopy it is helpful if you lay
pieces of packing foam out of the carton, as shown in
fig. 8, onto the base.
When you open the carton with the canopy you will
recognise on one of the long sides of the canopy two
soldered-on prongs, this side is the rear side and
has to face (during the ongoing assembly) to the
rear toward the tripod legs, which point upwards.
Now put down the canopy, as previously explained,
with the front part on to the styropor pieces. While your
offsider is holding the rear part of the canopy, you
fasten the splicing plates of the canopy on to the tripod
legs, which point upwards. Use from the assembly kit
one each of the Allen-key M 8 x 30, fanlike washer A
8,4; washer A 8,4 und distance case © 12 x © 8,2 x 7,5.
Stick the three latter pieces in the same sequence on
to the screw and screw the splicing plates of the
canopy onto the tripod legs. By doing this the distance
case will insert into the large sinking of the splicing
plate and establish its laying point. Screw together
both splicing plates in that manner and thoroughly
tighten the screws.
distance case
Washer
Fanlike washer
Allen-key
FIG. 9
Mounting the Gas Spring
On each gas spring included in the package, a securing
clip can be seen. These securing clips have to be taken
off, as shown in Fig. 10. The gas springs are to be
mounted on the ball-joints on both the canopy and
bench. Hold the gas spring, as shown in Fig. 11 and 12,
by placing over and pressing the ball-joint connector
onto the ball-joint. Test the installation by moving the
canopy up and down to check for easy movement.
Gas spring
Cotter pin-holes
Safety washer
Ball-joint
connector
Installation-
groove
FIG. 10
english
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dr. Kern Perfekt E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dr. Kern Perfekt E in the language / languages: English, German as an attachment in your email.

The manual is 1,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info