499401
23
Zoom out
Zoom in
Previous page
1/28
Next page
23
Maintenance of the face-tanner
The lamp of the face-tanner must also be maintained at
regular intervals. To do this, the filter cassette must be
taken out by removing the 4 screws shown below in Fig.
37.
Fig. 37
Remove these 4 screws
The top acrylic sheet is designed to be placed with
tension into the canopy grooves. To remove, press
inward in two places along the center of the sheet as
in fig. 26 and pull it out from the front groove, as that
edge will come free first.
Use the reverse method to replace. Slide the front-
ward edge of the sheet into its groove all the way in,
and then place the other edge into its groove. To do
this, the middle of the acrylic sheet must be
depressed in two spots.
NOTE: The acrylic sheet in the canopy was first
mounted in the factory as a flat sheet. After a while,
the operation of the unit and its removal and
replacement will cause the sheet to take on the form
of the canopy.
Fig. 27
Fig. 26
Press th mounting profile
slightly downwards
Fig. 25
Now press the pane and the mounting profile slightly
downward at several points along the rear side. When
sufficient pressure is applied, the pane and the
mounting profile will snap into place in the groove
along the rear side.
The acrylic sheets should be regularly cleaned. Use
only solvent-free, non-caustic materials.
WARNING: Only lamps listed on the warning / danger
label, or those with certified Compatibility Declarations
should be used as replacements. These lamps can be
purchased from your authorized distributor.
Turn each lamp so that one of the bi-pins can be seen
through the lampholder groove. Take the lamp out
carefully. Replace the new lamp in the reverse manner.
Then turn the lamp 90 degrees in the direction to
where the writing on the lamp is visible.
The starters should be changed with each lamp
replacement. To do this, press inward on the starter
and turn it until it comes free from its fixture. Replace
the new starter in the reverse manner.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dr. Kern excellent 32 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dr. Kern excellent 32 3 in the language / languages: English, German as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info