571279
22
Zoom out
Zoom in
Previous page
1/38
Next page
wijzigingen op grond van technische verbeteringen voorbehouden
22
1 Installation instructions
The installation and start-up must be carried out by specialist installers in accordance
with the NBN D51-003 standard.
During installation, have your installer explain how to use, operate and maintain your
appliance. Each appliance is tested, carefully adjusted and sealed in the factory in
accordance with category I2E+ (natural gas) or category I3+ (propane/butane). See
the identication plate for the type of gas for which your appliance is adapted. Any
modications of the controls by unauthorised persons will invalidate the warranty.
1.1 Choosing a location
Keep the connection between the connection collar and the ue pipe as short and
straight as possible. The minimum distance from the appliance to a ammable wall is
20 cm. Ensure that there are no curtains hanging above the appliance. Combustion
consumes oxygen. It is therefore very important that the space in which the appliance is
installed is adequately ventilated. Install ventilation of at least 15 cm² (not closable).
1.2 Connection to the ue pipe
The ue pipe must comply with the rules described in standard NBN B61-001.
Before connecting the appliance to a ue pipe to which a coal, wood or oil-red stove
was previously connected, it is best to have the ue professionally cleaned. Although
a gas stove can operate with a very small ue draught, we advise you to have the ue
checked every year. The appliance is connected to the ue using a 100 mm diameter
discharge pipe tted into the connection collar on the rear wall. Use corrosion-resistant
materials. This connection pipe should never come below the connection collar of the
stove.
Check whether the ue is working correctly by operating the appliance at full capacity
for ten minutes before holding a cold mirror or chromed object to the draught diverter
(behind the appliance below the connection collar). If the mirror or object mists up, the
ue is not functioning sufciently.
1.3 Connection to the gas supply
Check whether the gas type and the gas pressure correspond to the indications on the
identication plate. An approved AGB/BGV gas valve must be tted as close as possible
to the appliance.
The connection must be tension-free.
Check that the gas supply pipe has no leaks (e.g. using soapy water).
For pipes up to +/- 10 m in length, 3/8" G tubes or 10/12 diameter copper tubes are
adequate. For more than 10 m use 1/2" or 13/15 diameter copper tubes.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dovre 725GAP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dovre 725GAP in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dovre 725GAP

Dovre 725GAP Additional guide - English, German, Dutch - 1 pages

Dovre 725GAP User Manual - Dutch - 24 pages

Dovre 725GAP Additional guide - French - 1 pages

Dovre 725GAP User Manual - French - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info