784483
8
Zoom out
Zoom in
Previous page
1/64
Next page
8
THIS SIDE UP
. MOUNTING
Lead all cables and wires you want to connect to the device through the mounting housing (for retrofit version:
through the hole in the existing panel).
. DISASSEMBLING THE FRONT PANEL
(APPLIES ONLY TO THE SURFACE-MOUNTED AND FLUSH-MOUNTED MODEL)
Remove the front panel with the attached Main Electrical Unit carefully from the mounting housing (backbox)
using the orange (Torx+Pin) screw driver provided.
We have designed the front panel and the safety screw in a way that it cannot be screwed through the
front panel so that is does not fall off / get lost during installation..
Turn the safety screw counter-clockwise until it is loose. Pull the front panel with attached Main
Electrical Unit out of the mounting housing (backbox).
Flush-mounted model Surface-mounted model
Please make sure that the outer frame of the flush-
mounted housing rests on the outside of the wall
and that the edge of the flush-mounted housing
is sealed all around against moisture from the
outside.
Before mounting: Pierce through the middle
of the rubber seal for the cable entry using a
screwdriver.
THIS SIDE UP
Retro Fit model
Surface-mounted modelFlush-mounted model
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Doorbird A1121 Series IP Access Control Device at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Doorbird A1121 Series IP Access Control Device in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Doorbird A1121 Series IP Access Control Device

Doorbird A1121 Series IP Access Control Device Additional guide - English, German, French, Spanish - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info