507715
29
Zoom out
Zoom in
Previous page
1/52
Next page
29
ENG.
IMPORTANT, ATTENTION
This engine is shipped without oil. See
operating instructions for correct oil fill
capacity.
DO NOT OVERFILL
see engine manual for more detail.
STARTING:
Move the choke control to the ”CHOKE”
position .
Move the accelerator control to the “FAST”
position (1).
Move the stop control to the “ON” position
by pulling the lever, with the safety button,
against the handle (3).
Grasp rope handle and pull slowly until
resistance is felt. Then pull cord rapidly to
overcome compression, prevent kickback
and start engine. Repeat if necessary with
choke in RUN position and throttle
in FAST. When engine starts, operate in
FAST position.
STOPPING:
Move the accelerator control to the minimum
position (2), then move the stop control to
the OFF position, by releasing the lever (3).
IMPORTANT, ATTENTION
Ce moteur est expédié sans l’huile. NE PAS
METTTRE EN MARCHE avant d’avoir rempli le
carter moteur d’huile.
NE PAS DEPASSER LE NIVEAU MAXIMUM
Avant de passer à l’utilisation, consulter le
manuel du moteur ci-joint.
MISE EN MARCHE:
Amenez la commande de l’air en position
CHOKE
Amenez la commande de l’accélérateur
en position FAST (1)
Pour obtenir la commande d’arrêt,
positionnez le bouton-poussoir de sécurité
sur ON et tirez le levier contre le guidon (3).
Saisir la poignée de lanceur et tirer
lentement jusqu’à percevoir une
résistance. Tirer alors vivement sur la cor-
de pour vaicre le compression, prévenir
les retours et démarrer le moteur.
Si nécessaire répéter avec le starter sur
RUN et la commande d’accélération
sur FAST. Quand le moteur est démarré,
l’utiliser en position FAST.
ARRET:
Amenez la commande de l’accélérateur
en position de minimum (2); amenez
ensuite la commande d’arrêt en position
OFF, en relâchant le levier (3).
F
ON tirando la leva, con pulsante di sicurez-
za, contro il manubrio (3).
Afferrare la manopola della fune e tirarla
lentamente fino a sentire una certa resi-
stenza. A questo punto tirare rapidamente
la corda per superare la compressione,
evitare contraccolpi ed avviare il motore.
Se necessario ripetere la procedura con il
comando dell’aria in posizione RUN
ed il comando acceleratore in posizione
FAST. Una volta avviato il motore, farlo
funzionare nella posizione FAST.
ARRESTO:
Portare il comando acceleratore in posi-
zione di minimo (2); portare quindi il co-
mando d’arresto in posizione OFF, rila-
sciando la leva (3).
D
WICHTING, ACHTUNG
Der Motor wird ohne Öl geliefert. VOR DER
INBETRIEBNAHME den Ölbehälter füllen.
ÜBERSCHREITEN SIE NICHT DIE
HÖCHSTSTAND-MARKIERUNG
Vor dem Gebrauch dei beiliegenden
Anweisungen des Motoren-Herstellers
konsultieren.
ANLASSEN:
Die Luftsteuerung auf Position CHOKE
bringen
Die Beschleunigungssteuerung auf
Position FAST (1) stezllen
Die Aus-Steuerung auf ON stellen, indem
man den Hebel mit dem
Sicherheitsdruckknopf gegen den Griff (3)
zieht.
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dolmar PV3936 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dolmar PV3936 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 14,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info