507649
13
Zoom out
Zoom in
Previous page
1/28
Next page
13
AVOID SKIN AND EYE CONTACT
D
Mineral oil products degrease your skin. If your skin comes in
contact with these substances repeatedly and for an extended
period of time, it will desiccate. Various skin deseases may result.
In addition, allergic reactions are known to occur.
Eyes can be irritated by contact with oil. If oil comes into your
eyes, immediately wash them with clear water.
If your eyes are still irritated, see a doctor immediately!
Refuelling
FOLLOW THE SAFETY PRECAUTIONS!
Be careful and cautious when handling fuels.
The engine must be switched off!
- Thoroughly clean the area around the caps, to prevent
dirt from getting into the fuel or oil tank.
- Unscrew the cap and Þ ll the tank with fuel (fuel/oil mixture)
or chain oil as the case may be. Fill up to the bottom edge
of the Þ ller neck. Be careful not to spill fuel or chain oil!
- Tightly screw on the cap.
After refuelling, clean the tank cap and surroundings and
make sure the cap is sealed!
E
chain oil
Adjusting the chain lubrication
G
The engine must be switched off.
You can adjust the oil pump feed rate with the adjusting screw
(F/1). The adjusting screw is located in the housing underneath
the sprocket guard (F/2). It is accessible from below.
The oil pump comes factory-set to a medium feed rate.
Note: To set from minimum to maximum oil supply, turn the ad-
justing screw (F/1 with adjustment markings) max. a 1/4-turn.
Note: After the saw has been turned off it is normal for residual
chain oil to drip from the oil feed system, the guide bar and the
chain for a time. This does not constitute a defect!
Place the saw on a suitable surface.
To ensure troublefree operation of the oil pump the oil guide
groove at the crank case (G/3) and the oil inlet bore in the guide
bar (G/4) must be cleaned regularly.
To change the feed quantity use the universal wrench and adjust
the adjusting screw (F/1) in the following way:
- Turn to the right to reduce the feed rate.
- Turn to the left to increase the feed rate.
F
2
1
3
4
fuel/oil mixture
Lubricating the chain
During operation there must always be sufÞ cient chain oil in
the chain-oil tank to provide good chain lubrication. One Þ lling
is sufÞ cient for about one half-hour of continuous operation.
While working make sure there is enough chain oil in the tank.
If necessary, add oil. The engine must be switched off!
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dolmar 115 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dolmar 115 in the language / languages: English as an attachment in your email.

The manual is 3,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dolmar 115

Dolmar 115 User Manual - German - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info