Manual Dogtrace d-control AQUA spray 900 (page 9 of 15) (English)

766079

Zoom out

Zoom in

1/15

Note: When the battery is replaced quickly, the

beep may not sound.

Receiver preparation

Inserting (changing) the receiver battery

1. Remove the 4 screws from the underside of the

receiver and remove the lid from the top.

2. Insert the lithium CR2 3 V battery with the co-

rrect polarity (polarity is marked in the battery

compartment).

When inserting battery for the first time, or if the

battery is removed for longer than a couple tens

of minutes (approx. 20 minutes), a beep sounds

to indicate that battery has been inserted

correctly.

3. Check that the rubber seal is correctly positio-

ned in the receiver lid groove. If the rubber seals

are dirty, clean them.

4. Put the lid back on the receiver and replace the

screws.

Checking the receiver battery's status

To check the receiver battery, see the indicator light (LED) on the upper side of the

receiver (see chapter): Product description - Receiver.

Charged battery – when on, the LED ashes green

Low battery – when on, the LED ashes red

If the battery is at, insert new lithium battery CR2 3 V into the battery compartment.

Switching the receiver on/o

To turn the receiver on/o (e.g., when pairing

the transmitter and receiver), use the magnetic

switching system, activated by placing

the magnet stored in the lower part of the

transmitter near the correct receiver part.

Switching on:

1. Place the lower part of the transmitter near

the red target on the receiver (see picture) -

indicator light will shine red, then orange.

2. Once the light is orange remove the

transmitter from the receiver - the light will

shine green and start to ash.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control AQUA spray 900 in the language / languages: English as an attachment in your email.

The manual is 0,45 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Dogtrace d-control AQUA spray 900 Manual

Product: