163678
7
Zoom out
Zoom in
Previous page
1/12
Next page
Two fullrange speakersconnected in stereo
mode
One subwoofer connected in mono bridge
mode
The HP-filter is here used as
subsonic filter to take away
the very deepest frequencies
from the subwoofer. The
typical setting is around 25 –
40 Hz.
The LP-filter will allow low frequencies only and
blocks higher frequencies. A typical setting is 70 –
90 Hz. When used with a subwoofer the switch
should be in IN-position. Set the LP-filter to 70-90
Hz.
BASS is used to increase the bass volume with a
center frequency of 40 HZ. You can select the
amplification between 0 dB ( no amplification ) and
+18 dB (full amplification).
The phase control can be set continuously from 0
- 180 degrees. This is very useful when you want
to adjust the bass sound for best front stage image.
Start on 0 and turn the control slowly clockwise
until you experience that the bass sound is coming
from the front. If you dont get the result you want,
also try to phase reverse the subwoofer
connections and make a new adjustment.
Filter settings
NOTE!
4 ohm minimum load when using bridge mode
connection. Lower impedances may damage the
amplifier. In bridge mode the amplifier sees a 4
ohm load as 2 ohm.
7
Speaker wiring RA20
RA20 is a 2-channel stereo amplifier. It can be
connected either as a stereo amplifier for fullrange
speakers, or as a mono amplifier for subwoofers
connected in bridge mode.
RA20
With the HP-filter in OUT position the amplifier
allows the speakers to play fullrange. If you for
some reason want to limit the low bass
reproduction switch IN the HP-filter. The typical
setting is then around 60 – 80 Hz.
The LP-filter should be OFF
(switch in OUT-position).
Filter settings
+
-
-
-
+
+
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DLS ra20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DLS ra20 in the language / languages: English as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info