594203
16
Zoom out
Zoom in
Previous page
1/31
Next page
©2013-2014 DJI Innovations. All Rights Reserved. 16 |
Flight Test
Test Procedure
1. If in GPS Mode, place the aircraft in an open space without buildings or trees. Take off the aircraft after 6 or
more GPS satellites are found (LED flight indicator blinks red once or no blinking). If in ATTI. Mode, you can skip
this step.
2. Place aircraft 3 meters away from you and others, to avoid accidental injury.
3. Start-up
a) Switch on transmitter first, then power on aircraft! Keep the aircraft stationary until the system start and
self-check has finished.
b) Please wait for system to warm up gradually with LED flight indicator blinks Yellow 4 times quickly ( ).
You should not start the motors until the blinking disappears.
c) Keep aircraft stationary, and execute any one CSC to start the motors.
d) Release yaw, roll and pitch sticks and keep them at neutral position, at the same time raise the throttle stick
from the bottom. The motors will stop if you do not push the throttle stick from the bottom within 3 sec and
you will need to re-start the motors.
e) Keep raising throttle stick until all the motors are working, push the throttle stick to the mid position and then
take-off your aircraft gently, pay attention not to push the stick excessively.
f) Pay attention to the aircraft movement at any time, and use the sticks to adjust the aircraft's position. Keep the
yaw, roll, pitch and throttle sticks at the mid position to hover the aircraft at desired height.
4. Lower aircraft slowly until touch down is achieved. The motors will stop automatically after 3 seconds, or you can
repeat the start-up stick command to stop the motors sooner.
5. Please always power off aircraft first, and then switch off transmitter after landing.
(1) At the first motors start, the system will check the sensors Bias and you are asked to keep the
aircraft stationary (no need of horizontal level). If you cannot start the motors and the LED flight
indicator blinks Green 6 times quickly ( ), it means that the sensor error is too big. Please
connect the NAZA-M V2 Assistant Software, enter the "Tools" - > IMU calibration, carry out the basic
calibration. Note: after the first successful motors start, this checking will be disabled and it is no
need any more to keep the aircraft stationary during starting motors.
(2) If in GPS Mode, keep the aircraft flying in the open space without obstruction. Pay attention to the
GPS satellite status indicator. When the GPS signal has been lost for 3s (LED flight indicator blinks
red twice or three times), the system enters ATTI. Mode automatically.
(3) If battery voltage is too low for flying, the aircraft enters the first level protection with LED flight
indicator flashing quickly Red, please land ASAP. Once the aircraft enters the second level
protection, the aircraft will drop height automatically.
(4) If you want to put the PHANTOM FC40 in a car, please keep it away from the speaker, since the
compass module may be magnetized.
(5) DO NOT fly near to ferromagnetic substances, to avoid strong magnetic interference with the GPS.
(6) It is recommended to land the aircraft slowly, to prevent the aircraft from damage when landing.
(7) If transmitter indicates low battery alert, please land ASAP. In this condition the transmitter may
cause the aircraft to go out of control or even crash.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DJI Phantom FC40 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DJI Phantom FC40 in the language / languages: English as an attachment in your email.

The manual is 4,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DJI Phantom FC40

DJI Phantom FC40 User Manual - German - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info