594198

DJI Phantom 2 Vision plus Manual

49
Zoom out
Zoom in
Previous page
1/52
Next page
Appendix
©
2015 DJI. All Rights Reserved.
49
Remote Controller
Operating Frequency 5.728 GHz - 5.85 GHz
Communication Distance (open area) CE Compliance: 400m; FCC Compliance: 800m
Receiver Sensitivity (1%PER) -93dBm
Transmitting Power (EIRP) CE Compliance: 25mW; FCC Compliance: 100mW
Working Current/Voltage 120mA@3.7V
Battery 2000mAh rechargeable LiPo battery
Range Extender
Operating Frequency 2412MHz - 2462MHz
Communication Distance (open area) 500m - 700m
Transmitting Power 20dBm
Power Consumption 2W
3 Troubleshooting (FAQ)
3.1 How to solve large margin(s) mid-point error?
If the Remote Controller stick(s) mid-point margin of error is too big, the motors will fail to start when you execute the
CSC and the Phantom will not take off. The below are some possible xes for this.
(1) One of the Remote Controller’s stick positions (except the throttle stick) is not centered when powering on the
Phantom 2 Vision+.
Solution: Place all Remote Controller sticks at their mid-point positions and then power cycle the Phantom 2 Vision+
to re-record the mid-point.
(2) The Remote Controller sticks have been trimmed, leading to a deviation in the mid-point position.
Solution: Use Assistant to perform a Remote Controller calibration.
a) Connect to Assistant, tap Basic -> RC -> Command Sticks Calibration and push all Remote Controller sticks
through their complete travel range to see if any stick cannot reach its outermost position.
b) Power cycle the Phantom 2 Vision+. Power cycling is required.
c) Re-attempt Remote Controller calibration in Assistant.
If the above solutions do not solve your issue, please send your Remote Controller to DJI Customer service for repair.
3.2 How to restore a video le if power is turned off during a recording session?
Solution: Keep or place the Micro-SD card back into the camera. Power cycle the camera and wait about 30 seconds for
the video le to be restored.
3.3 Failure to acquire the SSID.
Solution: Double check whether both the camera and Range Extender are powered on and the power switch of the
camera is switched to “Wi-Fi ON.”
3.4 What to do if Phantom 2 Vision+ is out of sight and the Wi-Fi connections is lost?
Solution: Turn off the Remote Controller to trigger the Failsafe mode and the aircraft will start to y back, descend, and
land at the Home point. Please make sure there are no obstacles between the Phantom and the home point and that you
are familiar with the procedure for regaining control.
3.5 Wi-Fi connection fails all the time.
Solution: Double check the current Wi-Fi connection status of the mobile device. The mobile device may be connecting
to other Wi-Fi networks after a connection breaks with the Phantom 2 Vision+.
3.6 Files fail to synchronize.
Solution: Video les that are too large (le sizes close to 4GB) cannot be synchronized to the mobile device. Some
mobile devices do not support the synchronization of the 1080i60 video les.
Appendix
… 49 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DJI Phantom 2 Vision plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DJI Phantom 2 Vision plus in the language / languages: English as an attachment in your email.

The manual is 20,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DJI Phantom 2 Vision plus

DJI Phantom 2 Vision plus User Manual - German - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info