Manual Dirt Devil M 7066 Cargo (page 15 of 24) (English, German, French)

500172

Zoom out

Zoom in

1/24

5 Maintenance

5.3 Cleaning the exhaust filter

 Check the exhaust filter each time you check the motor protection filter,

ZChapter 5.2, ‘Cleaning the motor protection filter’.

 Clean the exhaust filter as soon as you see it is dirty.

 Replace the exhaust filter as soon as it deforms or is damaged

(ZChapter 5.4, ‘Spare parts and accessories’).

1. Switch off the appliance, ZChapter 4.3, ‘Switching off’.

2. Push down the release catch of the exhaust filter cover and fold down

the cover (Fig. 13/A).

3. Remove the exhaust filter from its holder (Fig. 13/B).

4. Thoroughly rinse the exhaust filter by hand under clear, cold or luke-

warm running water.

5. Put the new / cleaned and completely dry exhaust filter back into its re-

ceptacle (Fig. 13/B).

6. Fit the exhaust filter cover on the bottom side first (Fig. 14/A) and then

push it into its receptacle (Fig. 14/B). It might be easier if you push

down the release catch in the process (Fig. 13/A).

7. Check the exhaust filter cover for correct fit.

5.4 Spare parts and accessories

 Orders by fax or post: ZPage 48, ‘International Service’

 Further information: Z www.dirtdevil.de

5.5 Recommendation

We recommend: Swirl

AirSpace

Y50

dust filter bags with MicroPor

filtration

Swirl



, AirSpace



, MicroPor



and Y50



are registered trade marks of a company of the Melitta group and used with their permission.

5.6 Before you send in the appliance

Before contacting us (ZPage 48, ‘International Service’) or even sending

the appliance to us, use the table to check whether you can correct the

problem yourself.

click!click!click!

ATTENTION:

The filters are washable, but not suitable for cleaning in washing

machines or dishwashers. Do not use cleaning agents for cleaning.

Leave the filters to dry after cleaning them with water (approx. 24 hours

at room temperature). Only put them back into the appliance when they

are completely dry.

ATTENTION:

Only use original spare parts from the scope of delivery or those that you

have purchased by reordering.

Item number Description

7000022 Set of 5 dust filter bags and 1 motor protection filter

7066002 1 exhaust filter

M203-4 1 parquet brush

M208-8 1 turbo brush

M219 1 mini turbo brush

WARNING:

Danger of injury! Never use a defective appliance! Always switch off the

appliance and disconnect it from the mains before starting troubleshoot-

ing ZChapter 4.3, ‘Switching off’.

Problem Possible cause / solution

Filter bag

change indi-

cator (Fig. 1/

4) appears in

the display

window.

The dust filter bag is full. Change the dust filter bag,

ZChapter 5.1, ‘Changing the dust filter bag’.

Nozzle, tube, or suction hose is blocked.

Remove the obstacle. If necessary, use a long wooden

stick (e.g. a broomstick) to do this.

The filters are dirty. Clean the respective filter ZChapter

5.2, ‘Cleaning the motor protection filter’ or ZChapter 5.3,

‘Cleaning the exhaust filter’.

The vacuum

cleaner stops

suddenly.

The overheating protection has tripped (possibly due to

blocked suction channels, filters, or similar). Switch the

appliance off and pull the plug out of the socket. Eliminate

the cause of overheating (e g. remove blockage). Wait for

about 45 minutes. After the appliance has cooled off, you

may switch it on again.

The cleaning

results are

unsatisfac-

tory in spite of

the appli-

ance work-

ing correctly.

The bypass vent (Fig. 1/20) is open. Close the bypass

vent (Fig. 1/20).

The power setting does not suit the flooring. Set the pow-

er to the setting suggested for the flooring, ZChapter 4.2,

‘Vacuum cleaning’, step 4.

The position of the ‘carpet/hard floor’ selector (Fig. 1/29)

is unsuitable. Set the ‘carpet/hard floor’ selector (Fig. 1/

29) to the correct position for the type of floor, ZChapter

4.2, ‘Vacuum cleaning’, step 5.

The attached nozzle is unsuitable. Change the nozzle,

ZChapter 3.2, ‘Assembly’.

The dust filter bag is full. Change the dust filter bag,

ZChapter 5.1, ‘Changing the dust filter bag’.

The filters are dirty. Clean the respective filter ZChapter

5.2, ‘Cleaning the motor protection filter’ or ZChapter 5.3,

‘Cleaning the exhaust filter’.

Nozzle, telescopic tube or suction hose is blocked. Re-

move the obstacle. If necessary, use a long wooden stick

(e.g. a broomstick) to do this.

Problem Possible cause / solution

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Dirt Devil M 7066 Cargo in the language / languages: English, German, French as an attachment in your email.

The manual is 3,87 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Dirt Devil M 7066 Cargo Manual

Product: