320859
9
Zoom out
Zoom in
Previous page
1/18
Next page
9
GB
Operation
2 Operation
2.1 Unpacking
1. Unpack the appliance with all its
accessories.
2. Check the contents for completeness and
possible damages. Information regarding
the scope of delivery ZPage 8, "Parts of the
appliance".
2.2 Assembly
1. Insert the end of the suction hose into the
intake opening (Fig. 1/2) as shown until you
feel it snap into place. Make sure that the
release catch is showing exactly to the right
resp. to the left.
2. Insert the handle into the upper end of the
telescopic tube (Fig. 1/3).
3. Attach the floor nozzle to the bottom end of
the telescopic tube (Fig. 1/1).
4. Adjust the length of the telescopic tube.
Press down the release latch on the tube
(Fig. 1/5) to do this. Then extend the
telescopic tube to the desired length. Let go
of the release catch of the telescopic tube
while pulling until it locks in place. You will
hear a distinct click.
5. Attach the supplied nozzles of your choice
to the accessory clip (Fig. 5/1).
Your cylinder vacuum cleaner is now ready for
use.
2.3 Vacuum cleaning
1. Attach the desired nozzle to the suction
tube (Fig. 2 or Fig. 4 according to the
surface to be cleaned ).
2. Pull out the power cord by the plug up to the
yellow mark (Fig. 6/5).
3. Insert the mains plug into a socket with
ground/safety contact.
4. Switch on the cylinder vacuum cleaner with
the on/off switch (Fig. 6/2).
5. Set the carpet/hard floor switch (Fig. 3/1)
depending on the type of flooring:
for short- and deep-pile carpets,
runners (Fig. 3/2).
for hard floors, e.g. laminate,
tiles, PVC, etc. (Fig. 3/3)
6. When working with the cylinder vacuum
cleaner, pull if after you like a sleigh.
2.4 Switching off
1. Switch off the cylinder vacuum cleaner with
the on/off switch (Fig. 6/2) and pull the plug
from the mains socket.
2. Keep the plug in your hand.
3. Push the cord retracting button (Fig. 6/1) to
retract the power cord.
2.5 Transportation & storage
For transportation you can carry the
cylinder vacuum cleaner by the carrying-
handle.
To park it or when not working with it you
can hook the parking-hook onto the parking-
bracket (Fig. 7/1).
For storing the appliance you can hook
the storage hook onto the storage bracket
(Fig. 7/2).
It is recommended to retract the telescopic
tube first.(Fig. 1/5).
Before storing it for a longer time empty
the dust container and dispose of the contents
properly. ZChapter 3.1, "Emptying the dust
container"
Always store the appliance in a cool, dry
place and out of reach of children.
NOTE:
Immediately contact your dealer if you have
found damage resulting from transportation.
ATTENTION:
Always transport or ship the appliance in its
original packaging to avoid damage. Keep
the packaging for such an event.
Dispose of no longer needed packaging
material properly
WARNING:
Danger of injury! Only assemble the
appliance if it is not connected to the power
supply. Otherwise the machine might start up
and parts of your body, hair or pieces of
clothing might be sucked in.
WARNING:
Danger of injury! A damaged appliance must
never be used. Check the cylinder vacuum
cleaner and the power cord before each use.
WARNING:
Danger of injury! Make sure especially when
vacuum cleaning stairs that you always
remain above the appliance.
ATTENTION:
Only use the cylinder vacuum cleaner with
all filters intact, in dry condition and correctly
placed. Make sure that the openings of the
vacuum cleaner are not clogged. Otherwise
the vacuum cleaner might be damaged.
WARNING:
Danger of electric shock! If the red marking
(Fig. 6/4) is visible, retract the cord by
pressing the retract button (Fig. 6/1) to pull in
the cable up to the yellow mark again.
Otherwise the cord might break.
ATTENTION:
Follow the recommendations of the flooring
manufacturers.
NOTE:
Use the power control (Fig. 6/3) to adjust the
suction power to the type of floor to be
cleaned. With the bypass vent (Fig. 1/4) you
can quickly reduce the suction power if less
power is needed, e.g. to release objects
accidentally sucked in.
6
WARNING:
Danger of injury! During uncontrolled
retraction the power cord can whip around,
become an obstacle or overthrow objects.
Therefore keep the plug in your hand and
guide it during retraction of the power cord.
WARNING:
Danger of injury! Switch off the appliance
when not working with it and observe the
notices under ZChapter 2.4, "Switching off".
ATTENTION:
Make sure that you don't accidentally press
the dust container release catch when
carrying the cylinder vacuum cleaner.
ATTENTION:
Never store the appliance next to heat
sources (e.g. stoves or radiators). Avoid
exposing it to direct sunlight. Heat can
damage the appliance.
7
CentrinoX3.book Seite 9 Dienstag, 15. März 2011 10:07 22
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dirt Devil m 2730 0 centrino x3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dirt Devil m 2730 0 centrino x3 in the language / languages: English, German, Dutch, French, Italian, Turkish, Spanish as an attachment in your email.

The manual is 1,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info