665119
17
Zoom out
Zoom in
Previous page
1/151
Next page
EN
17
Preparatory work
Getting to know the appliance
Fig.
1
:
1
Handle;
2
OFF/MIN/MAX switch;
3
LED;
4
Dust bin release catch;
5
Dust bin;
6
Floor nozzle;
7
Brush roller;
8
Handle release catch;
9
Recharge-
able battery compartment cover;
10
Rechargeable
battery compartment release catch;
11
Floor nozzle
release catch;
12
Charging socket;
13
Mains adapter;
14
Wall mount;
15
Rechargeable battery
Unpacking and assembling
1
Check that the unpackaged contents are complete.
If you notice any transport damage or if anything is
missing, contact your dealer immediately.
2
Turn the
handle (Fig.
1
/
1
) vertically over the upper installa-
tion opening on the appliance body (Fig.
2
). In the
process, make sure that the cable does not become
trapped between the handle and the appliance body.
NOTE:
If you wish to remove the handle again, push the
handle release catch (Fig.
1
/
8
) with a stable,
pointed object, and pull the handle from the
appliance body.
3
Insert the handle into the upper installation open-
ing on the appliance body so that you feel and hear
it click into place (Fig.
3
).
4
Connect the appliance
body to the oor nozzle so that you hear and feel the
oor nozzle release catch click into place (Fig.
4
).
NOTE:
If you wish to remove the oor nozzle again at a
later time, push in the oor nozzle release catch
(Fig.
1
/
11
), thus releasing it. Then pull the appli-
ance body and the oor nozzle apart (Fig.
6
).
NOTE:
To set the assembled appliance down, set it down
on the oor nozzle and tilt the appliance body
forwards so that the stop catch on the oor nozzle
clicks into place (Fig.
5
). Connect the appliance to
the wall mount (Fig.
7
) when you wish to charge
or store it.
5
Push the rechargeable battery compartment re-
lease catch and remove the rechargeable battery
compartment cover (Fig.
8
).
6
Insert the recharge-
able battery into the rechargeable battery compart-
ment so that the contact surfaces are facing down-
wards (Fig.
9
).
7
Now push the rechargeable battery
into the rechargeable battery compartment so that it
audibly clicks into place (Fig.
10
).
8
Re-insert the re-
chargeable battery compartment cover and close it
so that it audibly clicks into place (Fig.
11
).
Charging the rechargeable battery
WARNING!
Risk of re or explosion! Only use the mains adapt-
er included in the scope of supply to charge the
rechargeable battery.
1
Connect the mains adapter cable to the charg-
ing socket on the appliance (Fig.
12
).
2
Connect the
mains adapter to a socket (Fig.
13
). The LED lights
up constantly in red to indicate the charging pro-
cess (Fig.
14
).
3
After a maximum of 4 hours, the LED
switches to green. The rechargeable battery is then
charged.
4
Disconnect the mains adapter from the
socket (to save electricity) and disconnect the mains
adapter cable from the appliance.
Installing the wall mount
1
Connect the handle of the appliance to the wall
mount.
2
Place the appliance against the wall, to-
gether with the wall mount, so that the oor nozzle
rests at on the oor (Fig.
7
).
3
Mark the positions
for the drilled holes with a pencil.
4
Drill the holes.
5
Remove the wall mount from
the handle and screw it to the wall with suitable fas-
tening accessories.
6
Insert the hole covers.
Switching the appliance on/o
NOTE:
When the LED ashes red, the rechargeable bat-
tery charge is low and the appliance will switch o
within 20 seconds. Fully charge the rechargeable
battery to use the appliance again > “Charging
the rechargeable battery” on page 17.
CAUTION!
Make sure that the surface can withstand the ro-
tating brush without becoming damaged.
▶   
To switch on the appliance, push the OFF/MIN/MAX
switch one position down (Fig.
15
/I). The appli-
ance vacuums at low suction power and the brush
on the oor nozzle rotates. The LED lights up green.
▶   
For full suction power, push the OFF/MIN/MAX
switch one position further down (Fig.
15
/II).
▶   
To switch o the appliance, push the OFF/MIN/
MAX switch all the way up (Fig.
15
/O). The appli-
ance switches o. The LED goes out.
!
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dirt Devil DD691 Renegade at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dirt Devil DD691 Renegade in the language / languages: All languages as an attachment in your email.

The manual is 4,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info