798062
17
Zoom out
Zoom in
Previous page
1/24
Next page
6.4 - Troubleshooting
The heat pump is not working
Check that:
The desired water temperature is higher than the temperature
of the water in the tank.
The appliance is connected to a power supply.
The green light is on.
The appliance is not in holiday mode (symbol ).
• The air intake or ambient temperature is under -7°C or over
+35°C (ELEC MODE displayed).
The timer has not been programmed to stop the appliance
operating ( «economy» light will be on).
•The appliance is not in load shedding mode.
• An error message is displayed on the screen (see § Error
message codes).
Do not adjust settings
on safety aquastat
• Condensates are not draining
(water present under the appliance)
Check that:
The drainage system is not blocked:
- Remove the cover (see § «External control» procedure).
- Check the opening.
The tubes do not have bends or ‘U’ shapes that could collect
water.
The end of the tube gives out onto open air.
•The tank is properly positioned (vertical position and no
tilting).
• Electrical back-up is not working
Check that:
Your electricity provider or your timer is not preventing the
appliance from functioning ( «Economy» light on).
• A heat-limiting safety thermostat for electrical back-up has
not been activated after over-heating (>85°C). If this is the
case, reset it.
Before resetting, check:
- That the heating element does not have limescale.
- Clean or replace if necessary.
6.6 - Sensor data
0
5
10
15
20
25
30
35
40
45
50
55
60
-10 -5 0 5 10 15 20 25 30 35 40
Température (°C)
Résistance
(kOhms)
All 4 sensors have the same ohmic values.
Reset button
(85°C) on safety
aquastat
• No hot water
Check that:
The volume of water consumed is not higher than the volume
in the tank.
The time period that the appliance operates is not too short
(12h minimum if connected to piping).
The water temperature is not set too low.
There is no recirculation pump.
6.5 - Drainage
1) Switch o the power supply.
2) Shut o the cold water inlet valve on the safety group.
3) Open the hot water valves.
4) Set the safety group to the drainage position.
- INSTALLER HEAT PUMP WATER HEATER 200 -270L AIR D/2 - MANUAL - 17
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex Edel 270 AIR D-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex Edel 270 AIR D-2 in the language / languages: English as an attachment in your email.

The manual is 2.49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dimplex Edel 270 AIR D-2

Dimplex Edel 270 AIR D-2 User Manual - Dutch - 48 pages

Dimplex Edel 270 AIR D-2 Installation Guide - Dutch - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info