798062
16
Zoom out
Zoom in
Previous page
1/24
Next page
Neglecting to clean the circuit board
and other electronic components in a
dusty environment can lead to a risk of
overheating and ignition.
6 - MAINTENANCE AND
TROUBLESHOOTING
In order to maintain eciency and improve durability
it is advised that an annual maintenance check be
carried out by a qualied professional.
• Any work on the heat pump must be
carried out by a qualied professional.
• Observe all health and safety rules !
• Any work on the refrigerant circuit must be
carried out by a qualied professional with a
Category 1 certicate of aptitude.
• It is strictly prohibited to release refrigerant gas
into the atmosphere.
The refrigerant must be collected before any
work is carried out on the circuit.
• Switch o the heat pump water heater before
opening it.
Wait for the fan to come to a complete stop
before starting work on the appliance.
•Do not get water on any of the electrical parts.
The pressure limiting device must be operated
regularly to eliminate limescale and to check
for blockages.
• Check the condition of the corrosion-proof
anode at minimum once per year.
6.1 - Water circuit / Condensate
draining
To check that the condensates are draining correctly:
- Remove the upper cover (see §«Electrical connections»
procedure).
- Check for blockages in the drainage outlet.
- Clean the condensate recovery trough, where deposits
from the air intake may have gathered.
- Clean the exible drainage hose.
The pressure limiting device must be switched on regularly to
eliminate limescale and to check for blockages.
Check that all hydraulic connections on the heat pump water
heater are watertight.
When draining the tank, ensure that there is a large enough air
inlet at the top to avoid any depression in the tank. The following
materials and products should be avoided:
- Brushes with steel bristles or pads
- Scouring powder
- Any bleach-based product or chlorinated derivative
In case of maintenance or if taking the heat pump water
heater out of service, please respect the environmental
protection regulations regarding recovery, recycling and disposal
of consumables and components.
The only maintenance work needed on the air intake circuit is to
clean the evaporator (at least once per year and dependent on
the quality of air intake).
If using air lters check if they are clean regularly. Clean and
replace if necessary.
The fan blades are sharp-edged and may cause injury; take care
not to damage or deform them.
6.2 - Air intake circuit
It is mandatory to periodically inspect for the cleanliness and the
absence of dust deposits on the electronic circuit board and the
electrical terminals:
• of the compressor;
• of the electrical resistance ;
• of the dierent condensers.
Verify the correct tightness of all lugs. Adapt the frequency
of inspection to the air quality. In a dusty environment more
frequent maintenance and inspection is necessary, at minimum 1
time per year.
6.3 - Electrical maintenance
.../...
The refrigerant circuit containing
ammable refrigerant complies with national
gas regulations.
In case of operating on the refrigerant circuit:
1) Secure the area you will be working in
2) Inform people of the potential danger
involved in the work
3) Check that the risk of inammation is
minimised
4) Avoid working in a conned space; the area
must be suciently ventilated
5) Check the area with an appropriate leak
detector before and during the work
6) Place a CO2 dry powder extinguisher near
the work area
The R290 refrigerant in the heat pump
circuit poses no risk to the environment,
but it is ammable.
The R290 refrigerant is odourless.
Do not damage the pipes in the refrigerant
circuit.
Do not handle a flame or any other flammable
source on the inside of the appliance.
If the refrigerant is leaking, unplug the
appliance, air out the room, and contact
customer service.
Do not use any mechanical means to speed
up the defrosting process.
Do not pierce or burn the appliance: in case
of intervention on the refrigerant circuit, the
refrigerant must be recovered. .../...
- INSTALLER HEAT PUMP WATER HEATER 200 -270L AIR D/2 - MANUAL-
16
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex Edel 270 AIR D-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex Edel 270 AIR D-2 in the language / languages: English as an attachment in your email.

The manual is 2.49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dimplex Edel 270 AIR D-2

Dimplex Edel 270 AIR D-2 User Manual - Dutch - 48 pages

Dimplex Edel 270 AIR D-2 Installation Guide - Dutch - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info