534680
63
Zoom out
Zoom in
Previous page
1/68
Next page
Dimension BST 768 / SST 768 User Guide
Troubleshooting 63
filament comes through the back of the head. Pull the filament
from the head while inserting the cartridge. Once the cartridge
latches, pull an additional 6 inches of filament through the head
(to make sure the filament is not caught at the cartridge receiver).
Then snip the filament approximately 1 inch from the fixed part of
the head.
5. Remove the filament from both drive block assemblies if there
is enough to remove by hand.
A. Select Reverse.
This causes the drive wheels to reverse, so the material
filaments can be backed out of the liquefier.
B. Grasp the filament from the drive blocks with your
fingertips, and gently pull it out of the drive wheels. Repeat
for second filament. If you are unable to easily remove
either filament, leave the filament in the drive block for
now.
6. Remove both drive block assemblies from the swivel part of the
head.
A. Set a material cartridge on top of the tray to support the
removed drive block assemblies.
B. Remove the support drive block first. Use a 7/64” Allen
wrench to remove the two screws securing the motor
assembly as shown in Figure 22.
63


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimension BST 768 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimension BST 768 in the language / languages: English as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info