534680
54
Zoom out
Zoom in
Previous page
1/68
Next page
54 Maintenance
Dimension BST 768 / SST 768 User Guide
5. Locate the shroud, the shroud-mounting screws, and shield, as
shown in Figure 19.
Figure 19: Shroud and shield location
6. Remove the two shroud mounting screws using a 3/32 inch
hex wrench.
7. Once the screws are removed, pull the metal shield down to
remove. Be careful not to bend or damage the shield.
8. Pull the shroud downward to remove it.
9. Clean the exposed tip with the bronze brush provided in the
Startup Kit.
10. Install the new shroud by pushing it up onto the tip.
NOTE
The shroud is keyed and can only be installed with the holes
offset to the rear.
11. Slide the metal shield back over the shroud.
12. Check that both the shroud and shield are positioned correctly.
NOTE
Apply a thin coat of anti-seize compound to the threads of the
shroud mounting screws.
13. Drive the two shroud-mounting screws into the shroud and
tighten, but do not over-tighten the screws!
WARNING
Screws are very hot!! Use gloves when
working in this area of printer!
Shroud
Shroud
Mounting
Screws (2)
Shield
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimension BST 768 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimension BST 768 in the language / languages: English as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info