534680
53
Zoom out
Zoom in
Previous page
1/68
Next page
Dimension BST 768 / SST 768 User Guide
Maintenance 53
Tip Shroud Replacement - SST Only
Due to repeated contact with the tip-wipe brush, it is normal for the
tip shroud to become worn. When chronic build up of material
around the tip area or clumps of burnt material become imbedded
in the part, replace the tip shroud.
1. Enter Maintenance, press Next, and access the Table
Maintenance function.
The head temperature decreases.
2. Using a 1/8-inch hex wrench, back out the two head-plate
mounting screws approximately 1/8 inch (see Figure 18). Do
not remove the screws.
3. Pull the head plate slightly away from the head until the right
side of the plate is clear of the mounting screw head.
4. Pivot the right side of the head plate upwards, and rest the
right side of the plate on the right mounting screw, as shown in
Figure 18. There is a small notch on the bottom of the plate for
this purpose.
Figure 18: Head plate in shroud replacement position
WARNING
Head area is very hot! Use gloves when
installing a new shroud!
Right Side
Mounting
Screw in
Retaining
Notch
Left
Side
Head
Plate
Mounting
Screw
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimension BST 768 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimension BST 768 in the language / languages: English as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info