648036

Di Blasi R7-E Manual

11
Zoom out
Zoom in
Previous page
1/16
Next page
5 CHECKS AND ADJUSTMENTS
5.4 Throttle cable
To take up slacks in the throttle cable, adjust device B
- fig. 10 or G - fig. 12 .Tighten the lock nut after
adjustment.
5.5 Idling
To adjust the engine idling speed (fig.10):
6 increasing: turn clockwise
6 decreasing: turn the screw C counterclockwise
5.6 Head lamp
The head lamp inclination may be adjusted after
loosening the two mounting screws.
5.7 Spark plug
The gap of the electrodes should be 0,3 0,4 mm.
Clean the spark plug with the wire brush located in
the tool box.
Tithening torque of the spark plug on the cylinder
head: 28 Nm
5.8 Magnetowheel
The spark plug ignition is provided by an electronic
magnetowheel.
The spark advance is 22° 24° corresponding to 2,30
2,45 mm before the top dead center.
the screw C
÷
÷
÷
5.9 Nuts and bolts
All nuts and bolts are equipped with locking
devices (lock nuts, self locking nuts, lock
washers). Nevertheless, check the tightening
periodically.
5.10 Wiring harness
See electric diagram:
6 In the European mopeds: fig. 22 EU
6 In the USA mopeds: fig. 22 US
5.1 Handlebar hook
The locking hook is secured by two springs (A-
fig.14). Before riding, be sure that both springs are
working properly.
The correct position of the hook is illustrated in
fig.14. If the hook goes out of adjustment (as
illustrated in fig.13 and 15), readjust as follows:
6 loosen the screw (B) for a fraction of turn;
6 turn the knurled eccentric ring (C) until the
hook assumes the position indicated in fig. 14;
6 tighten again the screw (B)
5.2 Handlebar hinge
If the handlebar hinge feels loose, tighten the lock nut
(A-fig. 16) to take out the slack without
overtightening.
The handlebar stem must still swivel reasonable easy.
5.3 Brakes
The brakes may be adjusted at the handbrake levers
(F-fig. 12) and at the brake backing plate (A-fig.17)
After each adjustment tighten the correspondent nut.
With the brake levers in their normal position, the
wheels must turn freely.
To check the brake lining thickness, remove the
rubber plugs located in the brake backing plates (B-
fig. 17).
Fig. 13 Fig. 14 Fig. 15
A
B
C
NO NOOK
Fig. 16 Fig. 17
A
A
B
B
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Di Blasi R7-E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Di Blasi R7-E in the language / languages: English as an attachment in your email.

The manual is 2,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Di Blasi R7-E

Di Blasi R7-E User Manual - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info