648036

Di Blasi R7-E Manual

9
Zoom out
Zoom in
Previous page
1/16
Next page
6 Open the throttle slightly, by twisting the right
handlebar grip (B-fig.12).
6 Start the engine by pushing down the kick starter
lever with the foot.
6 A few seconds after that the engine as started,
release the choke to its open position by opening
the throttle completely and immediately closing
it. Prolonged operation with the choke on will
cause spark plug fouling. Use caution to insure
that the vehicle is on its stand and apply the
front brake while the throttle is opened
completely.
6 Get on the vehicle assuming the riding position.
6 With the throttle in the closed position, apply the
rear brake before pushing the vehicle off its
stand.
6 Once started, the vehicle is driven at the desired
speed solely by use of the twist grip throttle (B-
fig12)
4.6 Horn
The push button for the horn (color blue) is located on
the left side of the handlebar (fig.12 - E).
4.7 Turn signal lamps
The switch (T) for the turn signal lamps is located:
6 In European mopeds: on the right of the
handlebar (fig.12 EU);
6 In USA mopeds: on the left of the handlebar
(fig.12 US);
4 OPERATING INSTRUCTIONS
4.1 Running-in
During the first 500 km (300 mls), use a mixture of
regular gasoline with 4% two stroke oil and do not
operate at more than 3/4 throttle. At about 500 km
(300 mls) check all bolts and nuts for proper tightness
and tighten the cylinder head nuts at 10 Nm torque.
4.2 Fuel
After the first 500 km (300 mls) use a mixture of regu-
lar gasoline with 2% two stroke oil.
CAUTION: an improper mixture or just fuel without
oil will cause damages and voids all warranties.
4.3 Tyre pressure
Front: 1,2 atm (18 psi)
Rear: 1,8 atm (26 psi)
4.4 Riding
6 Place the vehicle on its stand and make sure that
the rear wheel is rised from the ground.
6 Open the fuel tap placed under the tank turning
the lever straight down to ON or straight up to
reserve (fig.9).
6 If the engine is cold, push down the choke lever
located on the carburetor (A-fig.10).
6 In USA mpeds only: move the red switch (S-fig.
12 US) located on the right side of the handlebar
into RUN position.
6 To slow down, close the throttle and, if necessary,
apply the brakes.
6 The vehicle is equipped with two brakes. The
front wheel brake is controlled by the lever on
the right side of the handlebar (C-fig 12). The
rear wheel brake is controlled by the lever on the
left side of the handlebar (D-fig.12). Under
normal stopping conditions, use the rear brake
only. Use the front brake only if necessary and in
conjunction with the rear brake: in any case very
softly and with extreme caution. Hard, sudden
use of the front brake can be very dangerous.
6 With the throttle in the closed position, the engine
will run while the vehicle is stationary.
6 To stop the engine:
- In European mopeds: close the throttle and
press the red button (S) located on the left
side of the handlebar (fig.12 EU).
- In USA mopeds: close the throttle and move
the red switch (S), located on the right side of
the handlebar, into STOP position (fig.12 US).
4.5 Lights
The switch for the lights is located on the left side of
the handlebar (L-fig.12)
6 In European mopeds: the three positions of the
switch correspond to: off, low, high beam.
6 In USA mopeds: lights are always switched on
when engine runs. The three positions of the switch
correspond to: low beam, high beam, flashing.
Fig. 9
Fig. 10
Fig. 12 EU
Fig. 12 US
B
B
A
A
C
B
C
D
E
F
F
G
L
S
T
B
C
D
E
F
F
G
L
ST
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Di Blasi R7-E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Di Blasi R7-E in the language / languages: English as an attachment in your email.

The manual is 2,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Di Blasi R7-E

Di Blasi R7-E User Manual - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info