658408

Derby Cycle Pedelec Xion 2013 Manual

58
Zoom out
Zoom in
Previous page
1/259
Next page
VIII User Manual Pedelec Xion 25
* All ve LEDs ash quickly: The battery is empty and is
being switched o, is overloaded or is going through the
start mode.
• If the battery is empty, it will work once again
briey following a short period of rejuvenation and
will then switch back o. It must now be recharged
• If the battery is overloaded, it will switch back
on aer a short idle period and can then be used
normally.
** The rst LED ashes quickly: A charging fault is pre-
sent.
• In that case, please remove the mains plug om
the socket and then plug it in again aer a short
time. The charger performs a readjustment. In most
cases, this recties the fault.
• If the LED continues to ash, overheating or under-
cooling of the battery may also be the cause. If, for
example, you charge the battery in a cold environ-
ment at a temperature below 0°C, or the battery
heats up to over 60°C during a long ascent, the
management switches o to protect the battery. In
such cases, the battery must be taken to a warmer
environment or cool down.
• If the LED still ashes, take the battery to your
specialist cycle shop and have it checked.
7.4.2 Checking the battery capacity
When you press the button with the LED for approx. three
seconds, the LEDs indicate the charge state rst, and then,
aer a short pause, the current capacity of the battery. If
the LED in the largest panel lights up, then the battery has
a capacity of over 60%. If the capacity is below 60%, this
is indicated via the smallest LED. Only one of the two LEDs
can light up at any one time.
The range of the battery is less in winter due to the
lower temperatures. Only move the battery (om the
warm room where you store it) and t it on your Pe-
delec just before you set o. This will help to prevent
the eect of the low temperature on the range of the
battery (➠ Chapter 7.5.1 “Service life and warranty
of the battery”).
7.4 Battery information system
There is a display panel on the outer face of the battery
which includes ve LEDs and a button with an LED. The
LEDs light up if you press the button. Information about
the battery and its charge state is provided based on the
number of LEDs that light up and the way in which they
light up.
Battery charge state
7.4.1 Checking the battery charge state
Press the button with the LED briey; the LEDs light up
and display the current battery charge state.
AFFICHAGE
ÉTAT DE CHARGE DE LA
BATTERIE
•••••
5 LEDs light up 100 – %
••••
4 LEDs light up  – %
•••
3 LEDs light up  – %
••
2 LEDs light up  – %
•
1 LED lights up  – %
¡
1 LED ashes  – %
5 LEDs ash
quickly
%, surcharge ou la
batterie est en mode de
démarrage*
1
st
LED ashes
quickly
Erreur de chargement **
… 58 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Derby Cycle Pedelec Xion 2013 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Derby Cycle Pedelec Xion 2013 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 19,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info