531764
114
Zoom out
Zoom in
Previous page
1/145
Next page
113
Extract:
Reservoir cap (threaded)
- Fill the reservoir with brake fluid up to the top reservoir
line.
- With the cap removed, pump the brake pedal slowly several
times until no bubbles can be seen rising through the liquid.
Purge the air completely from the main cylinder using the
following procedure:
- Remove the transparent plastic cap from the bleed valve
and place the other end of the pipe in a container.
- Repeat the following procedure until there is no air left
emerging from the plastic pipe:
- Pump the brake pedal until it becomes hard and holds the
brakes down.
- Open and close the purge valve quickly while keeping the
brake on.
- Release the brake.
NOTA
CHECK THE FLUID LEVEL FREQUENTLY DURING THE
BLEEDIING OPERATION AND REPLENISH THE RESERVOIR
WITH BRAKE FLUID WHEN NECESSARY. IF THE RESERVOIR
EMPTIES COMPLETELY OF BRAKE FLUID AT ANY TIME THE
DURING BLEEDING PROCEDURE, PERFORM THE BLEEDING
PROCEDURE ALL OVER AGAIN FROM THE BEGINNING,
SINCE AIR WILL HAVE ENTERED THE PIPE. TAP THE BRAKE
PIPE LIGHTLY FROM THE CALLIPER TO THE RESERVOIR TO
ACHIEVE A MORE COMPLETE BLEEDING.
- Extract the transparent plastic pipe.
Fit:
- Reservoir cap.
- Tighten the bleed valve and fit the rubber hood.
- Check brake fluid level.
- Once the bleeding process has been carried out, check the
efficiency of the brake to see if there is any resistance or any
fluid loss.
114


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Derbi GPR 125 cc Racing at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Derbi GPR 125 cc Racing in the language / languages: English as an attachment in your email.

The manual is 6,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info