584591
14
Zoom out
Zoom in
Previous page
1/18
Next page
NOTE
No signal is output from the “–” terminal of speaker A, or the speaker B terminal.
Use speakers with an impedance of 4 ~ 16 Ω/ohms.
Do not connect a speaker using other than the specified combination of channels.
Bridge Connections
This connection is used to use two power amps to output opposite phase signals generated from
one input signal using two power amp units.
By connecting the output (+ side) of the two power amps to the speaker, a larger output than in a
normal connection is possible.
Bridge output is setup using the following combination of channels. The input terminals to be used are
as follows.
·
and input terminal :
channels
·
and input terminal :
channels
·
and
input terminal :
channels
·
and
input terminal :
channels
·
and
input terminal :
channels
Set each switch as shown below.
q Set the Operation mode select switch to “BRIDGE” (vpage 6).
w Set the Input select switch according to the input (vpage 6).
· For RCA input ·········· Set to “RCA”.
· For XLR input ·········· Set to “XLR”.
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
w q
"6%*0
065
13&13&
065
Example: Bridge connection using and channels
b Setup each pair channel using the same steps.
NOTE
The input terminal (channel in case of and ) that is not used for this setting becomes
invalid regardless of the status of
Input select switch
.
About output by this connection, the voltage applied to the speaker is 6 dB higher than the output
when the normal connection is used. Adjust the input signal using the volume of the pre-amp when
connecting.
Input select switchOperation mode select switch

Getting Started Connections and Settings Operations Troubleshooting
1.POA-A1HDCIEU.indd 14 2008/01/18 11:07:23
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon POA-A1HDCI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon POA-A1HDCI in the language / languages: English as an attachment in your email.

The manual is 5,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info