584606
12
Zoom out
Zoom in
Previous page
1/37
Next page
12
ENGLISH
7
OPERATION
(1) Playback
PROG/
DIRECT
SYSTEM
POWER
OFF ON
2
STOP PLAY
VOLUME
/SELECT
SLEEP MODE
TAPE
FUNCTION
PRESET
+
-
TUNER
CD
MD
3
5
3
Either turn the FUNCTION dial on the main unit
or press the remote control units FUNCTION
button to select the function source to be
played.
The function switches in the order shown
below.
The function switches in the opposite order
when the dial is turned counterclockwise (.).
CD
MD TAPE PHONO
TUNER DVD/AUX
FUNCTION
FUNCTION
(Main unit) (Remote control unit)
4
Start playback of the selected function source.
For instructions on operation, refer to the
components operating instructions.
5
Adjust the volume.
6
Adjust the BALANCE, BASS, and TREBLE
controls and set the LOUDNESS position to the
desired position.
For instructions on adjusting, see (3) Setting
the various modes on page 12, 13.
7
To use the source direct function:
Press the SOURCE DIRECT button to display
SD ON .
VOLUME
VOLUME
/SELECT
(Main unit) (Remote control unit)
(Main unit)
1
Check that all connections are correct.
2
Turn on the power.
The indicator first flashes green, then after
about 6 seconds stops flashing, remaining lit,
indicating that the unit is set to the power on
mode.
(Main unit)
SYSTEM
ON / STANDBY
SYSTEM
POWER
ON
(Remote control unit)
2 Power on/standby mode and function
memory
B
When the remote control unit is used to
turn the DRA-F101s power on from the
standby mode, the function is set to the
function that was selected when the
power was last set to the standby mode.
(Last memory function)
B
If the function has been cleared from the
memory, the function is set to CD when
the DRA-F101s power is turned on.
(3) Setting the various modes
[1] Adjusting the bass and treble
PHONES
SYSTEM
VOLUME
ON / STANDBY
AM-FM STEREO RECEIVER DRA-F101
SOURCE
DIRECT
BANDUPDOWN
TUNING
MEMORY
/ SET
FUNCTION
TIMERTONE DISPLAY
2 1
STOP PLAY
VOLUME
/SELECT
SLEEP MODE
TAPE
FUNCTION
PRESET
+
-
1
2
1
2
Press the TONE or MODE button to display the
mode to be adjusted (BASS or TREBLE).
Either turn the FUNCTION dial on the main unit
or use the remote control units SELECT
buttons.
BASS
Playback
function source
BALANCE
TREBLE LOUDNESS
TONE
(Main unit)
MODE
(Remote control unit)
FUNCTION
VOLUME
/SELECT
(Main unit) (Remote control unit)
To increase the bass or treble:
Turn the dial clockwise (,) or press the
D
button.
To decrease the bass or treble:
Turn the dial counterclockwise (.) or press
the
H
button.
The bass and treble can be adjusted within
the range of 8 to 0 to +8 in steps of 2. The
response is flat at 0.
The mode switches as follows each time the
button is pressed:
This cannot be selected when the source
direct mode is set to ON.
(decrease) (increase)
(decrease)
(increase)
SOURCE
DIRECT
(2) Recording
1
Follow step 1 to 4 under (1) Playback.
2
Start recording on the cassette deck or MD
recorder.
For instructions, refer to the components
operating instructions.
Operating the VOLUME, BALANCE, BASS,
TREBLE and the LOUDNESS controls will not
affect the sound being recorded.
When the function source is set to MD,
recording is performed from the MD recorder
onto the cassette deck. When the function
source is set to TAPE, recording is
performed from the cassette deck onto the
MD recorder.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon D-F101S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon D-F101S in the language / languages: English, Spanish as an attachment in your email.

The manual is 1,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info