83
Advanced Setup – Part 2 Advanced Setup – Part 2
ENGLISH
ENGLISH
Setting the low frequency distribution
• Set the subwoofer mode according to the speaker system
being used.
• Select the play mode that provides bass reproduction with
body.
Setting the Distance
Input the distance between the listening position and the
different speakers to set the delay time for the surround mode.
Preparations:
Measure the distances between the listening position and the
speakers (L1 to L10 on the diagram at the below).
1
Press the CURSOR
DD
or
HH
button to select
“Subwoofer Setup” at the “Speaker Setup”
menu, then press the ENTER button.
• The “Subwoofer Setup” screen appears.
2
Press the CURSOR
FF
or
GG
button to select the
setting.
LFE:
For any channel(s) that are set to LARGE, low frequencies in
that channel’s corresponding source are directed to that
loudspeaker only. Low frequencies that are directed to the
subwoofer(s) are from the program source LFE channel, and
from other channels where the speakers are set to SMALL.
LFE+Main:
Low frequencies from speaker channels that have been set to
LARGE are reproduced from those speakers as well as from
the subwoofer(s). Depending upon the characteristics of the
LARGE main speakers, this mode may provide a more even
low frequency response throughout the listening room.
1
Press the CURSOR
DD
or
HH
button to select
“Distance” at the “Speaker Setup” menu, then
press the ENTER button.
• The “Distance” screen appears.
3
Press the CURSOR
DD
or
HH
button to select the
speaker to be set.
2 Assignment of low frequency signal range
•The only signals produced from the subwoofer channel are
LFE signals (during playback of Dolby Digital or DTS signals)
and the low frequency signal range of channels set to “Small”
in the setup menu. The low frequency signal range of
channels set to “Large” are produced from those channels.
2 Subwoofer Setup
•The subwoofer mode setting is only valid when and “Yes” is
set for the subwoofer in the “Speaker Configuration” settings
( page 82).
•When the input signal is analog or a PCM signal not including
LFE signals, if “LFE” is selected, the low frequency
component is not output from the subwoofer. To output the
subwoofer channel, select “LFE+Main”.
C FRFL
SW
Listening position
SLA SRA
SLB SRB
SBL SBR
2
Press the CURSOR
FF
or
GG
button to select the
desired unit, “Meters” or “Feet”.
• The “Distance” screen appears automatically.
Example: When “Meters” is selected
.... L1
.... L2
.... L3
.... L4
.... L5
.... L6
.... L7
.... L8
.... L9
.... L10
A subwoofer with sufficient low frequency playback capability
can better handle deep bass than most main and surround
speakers, and the system’s overall performance will be
greatly enhanced when SMALL is set for the main (front) and
surround speakers.
When “Front” is set to “Small”, “Subwoofer” is automatically
set to “Yes”, and when “Subwoofer” is set to “No”, “Front”
is automatically set to “Large”.
3
Press the ENTER button to enter the setting.
• The “Speaker Setup” menu reappears.
