ENGLISH
35
Advanced Operation
ENGLISH
Advanced Operation
Multi zone music entertainment system
•ZONE2 speaker out can be used when “ZONE2” is selected at “Power Amp Assignment”. In this case, surround back speaker out
cannot be used for MAIN ZONE.
•When a sold separately room-to-room remote control unit (DENON RC-616, 617 or 618) is wired and connected between the MAIN
ZONE and ZONE2, the remote-controllable devices in the MAIN ZONE can be controlled from ZONE2 using the remote control unit.
•For instructions on installation and operation of separately sold devices, refer to the devices’ operating instructions.
2When using the SURR.BACK/ZONE2 amplifier as the ZONE2
•To use the ZONE2, turn on the ZONE2 button.
•The output of the ZONE2 SPEAKER OUT terminals can be adjusted with the remote control unit’s ZONE2 VOLUME button.
•The input source selected with the INPUT SELECTOR knob is output for the ZONE2 speaker output.
[System configuration and connections example]
Using this unit’s internal amplifier as the ZONE2.
: SPEAKER cable
: ROOM-TO-ROOM REMOTE CONTROL SYSTEM (separately sold) control line
Refer to “Connections” ( page 11).
Remote control unit operations during
multi-source playback (selecting the source)
1Set the MODE 1 switch to the “AUDIO”.
2Set the MODE 2 switch to the “ZONE2”.
3Press the ZONE2 ON button.
To cancel the ZONE2 mode:
Press the ZONE2 OFF button.
4The output level of the ZONE2 SPEAKER OUT
terminals can be controlled pressing the
VOLUME button on the remote control unit.
Default setting (ZONE2 VOLUME LEVEL):
– – – dB (MINIMUM)
This is only possible when the main unit in the ZONE2 mode
( page 16).