498673
16
Zoom out
Zoom in
Previous page
1/59
Next page
To increase the bass or treble: Turn the
control clockwise. (The bass or treble sound
can be increased to up to +10 dB in steps of
2 dB.)
To decrease the bass or treble: Turn the
control counterclockwise. (The bass or treble
sound can be decreased to up to 10 dB in
steps of 2 dB.)
16
ENGLISH
3
Select the play mode.
Press the SURROUND MODE button, then turn
the SELECT knob.
Example: Stereo
The volume can be adjusted within the
range of 60 to 0 to 18 dB, in steps of 1 dB.
However, when the channel level is set as
described on page 18, if the volume for any
channel is set at +1 dB or greater, the
volume cannot be adjusted up to 18 dB. (In
this case the maximum volume is adjusted
to 18 dB (Maximum value of channel
level).)
Input mode when playing DTS sources
Noise will be output if DTS-compatible CDs or LDs
are played in the ANALOG or PCM mode.
When playing DTS-compatible sources, be sure to
connect the source component to the digital input
jacks (OPTICAL/COAXIAL) and set the input mode
to DTS.
4
Start playback on the selected component.
For operating instructions, refer to the
components manual.
5
Adjust the volume.
(Main unit) (Remote control
unit)
The volume level
is displayed on
the master
volume level
display.
To select the surround mode
while adjusting the surround
parameters, channel volume
or tone control, press the
surround mode button then
operate the selector.
(Main unit)
(Main unit) (Remote control unit)
Input mode display
ANALOGDIGITAL
DIGITAL
DIGITAL
ANALOG
AUTO
PCM
DTS
INPUT
AUTO
PCM
DTS
INPUT
AUTO
PCM
DTS
INPUT
AUTO
PCM
DTS
INPUT
In the AUTO mode
In the DIGITAL PCM mode
In the DIGITAL DTS mode
In the ANALOG mode
One of these lights,
depending on the input
signal.
Input signal display
SIGNAL
DIGITAL
DIGITAL
DIGITAL
SIGNAL
SIGNAL
DOLBY DIGITAL
DTS
PCM
The indicator lights when digital signals
are being input properly. If the indicator
does not light, check whether the digital input
component setup (page 12) and connections are
correct and whether the components power is
turned on.
DIGITAL
DIGITAL
NOTE:
The indicator will light when playing
CD-ROMs containing data other than audio
signals, but no sound will be heard.
DIGITAL
123
[1] Adjusting the sound quality (tone)
After starting playback
1
The tone switches as follows each time the
TONE CONTROL button is pressed.
2
With the name of the volume to
be adjusted selected, turn the
SELECT knob to adjust the level.
(Main unit)
3
If you do not want the bass and treble to be
adjusted, turn on the tone defeat mode.
(Main unit)
The signals do not pass
through the bass and treble
adjustment circuits, providing
higher quality sound.
BASS TREBLE
(Main unit)
2
[2] Listening over headphones
1
Connect the headphones to
the PHONES jack of the front
panel.
1
PHONES
NOTE:
To prevent hearing loss, do not raise the volume level
excessively when using headphones.
2
Press the SPEAKER A or B
button turn the speaker off.
(Main unit)
CAUTION: No sound is produced from the
headphones when speakers A or B
are turned on.
1
Use this to turn off the audio
output temporarily.
Press the MUTING button.
Cancelling MUTING mode.
Press the MUTING
button again.
Muting will also be cancelled when
MASTER VOL is adjusted up or down.
(Remote
control unit)
[3] Turning the sound off temporarily (muting)
1
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon AVR-1404 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon AVR-1404 in the language / languages: English, German as an attachment in your email.

The manual is 4,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info