133693
33
Zoom out
Zoom in
Previous page
1/92
Next page
SINGLE SPLIT
13
ENGLISH
INSTALLING THE OUTDOOR UNIT
INSTALLATION
LOCATING THE OUTDOOR UNIT
The outdoor unit may stand on the floor or be wall
mounted, provided it is well supported and vibrations
are not transmitted to adjacent rooms.
It is advisable to avoid installation:
In pits or air vents;
Where obstacles or barriers could cause the expel-
led air to recirculate;
In places with an aggressive atmosphere;
In restricted places where the noise level of the
appliance could be increased by reverberation or
resonance;
in corners where dust, leaves or such usually accumu-
late and could reduce appliance efficiency by obstruc-
ting the passage of air.
Floor standing
When installing on the floor or a flat deck, the feet need
not be fixed to the ground. Supports are instead placed
underneath (~90÷100 mm) to allow application of the con-
densate drain pipe.
Place vibration-isolation mountings (not provided in the
kit) between the feet and the supporting base.
Wall mounted
When wall mounting, the recommended minimum clearan-
ce must be observed and a supporting kit is used that must
be ordered separately.
Carefully check that the structure and the load-bearing
capacity of the supporting wall are suitable.
Ensure that the recommended clearance given in the
“Technical Data” table is left around the appliance.
The manufacturer cannot be held liable for any damage
or injury caused by failure to earth the appliance or to
comply with the instructions given in this booklet.
Where air expelled from the appliance could enter
inhabited rooms through doors or windows, since
this would cause discomfort to the persons indoors;
Where air expelled from the appliance is opposed by
wind in the opposite direction;
Where sunlight falls directly on the appliance.
Before starting installation, decide on the position of
the indoor and outdoor units, taking into account the
minimum clearance required, the max. length of the
refrigerant lines and the difference in level between
the units.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi pls 120 ar at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi pls 120 ar in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 3,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info