800385

DeLonghi PAC ES Pinguino Manual

13
Zoom out
Zoom in
Previous page
1/123
Next page
12
INTRODUCTION
Thank you for choosing this De’Longhi product. Please take a few
minutes to read these instructions. This will prevent running any
risks or damaging the appliance.
DESCRIPTION
Description of the appliance (see page 2 - A)
A1 Air outlet grille
A2 Control panel
A3 Handles
A4 Wheels
A5 Rear lter
A6 Side lter
A7 Air intake grille
A8 Air exhaust hose housing
A9 Air intake grille
A10 Power supply cable
A11 Upper drain connection with cap
A12 Lower drain connection with cap
A13 Remote control compartment
Description of accessories (See page 2 - B)
B1 Air exhaust hose
B2 Hose adapter
B3 Adapter for wall mounting /window
B4 Adapter for window
B5 Wall ange with cap
B6 Remote control
ELECTRICAL CONNECTION
Before plugging into the mains, check the following:
• the mains voltage is the same as that indicated on the plate
on the back of the appliance;
• the socket and electrical line are sized to support the load
required;
• the socket is the proper type for the plug, otherwise, re-
place the socket;
• the socket is connected to an ecient earthing system. The
manufacturer is not responsible in the event of non-com-
pliance with these injury prevention standards.
• The power cable must only be replaced by special-
ised technicians.
USE
The instructions below will enable you to prepare your air con-
ditioner for operation as eciently as possible. Before use, make
sure the air intake and outlet grilles are unobstructed.
Maintain a minimum distance of 60 cm from walls and obstacles
(Fig. 3).
In conditioning and dehumidication the air exhaust hose (B1)
must be applied (Fig. 1).
Please note: This appliance is provided with an auto-evapora-
tion feature for condensate removal during cooling and dehu-
midifying mode.
AIR CONDITIONING WITHOUT INSTALLATION
CASEMENT WINDOW
If you have a casement window proceed as follows:
• Fit the air exhaust hose (B1) in the relevant housing located
on the rear side of the appliance (Fig. 1).
• Position the air exhaust hose (B1) with the window adapter
(B4) outside the window to let the hot air out (Fig. 2).
AIR CONDITIONING WITH INSTALLATION
If desired, the appliance can also be installed in a semi-perma-
nent manner.
In this case, it is necessary to:
• Drill a hole (diam. 150 mm) in a perimeter wall, or through
the glass of a window. Respect the height and dimensions
of the hole indicated in the gure shown below.
150
MAX 100 cm
MIN 35 cm
• Apply the supplied ange accessory B5 in the hole.
• Position the air exhaust pipe (B1) in the dedicated seat at
the rear of the appliance (g. 1).
• Attach the end of the pipe B1 to the ange B5 as shown in
g. 9.
Limit the length and bends in the air pipe as much as pos-
sible, avoiding any bottlenecks.
in the glass
of the
window
in the wooden
base of the
French window
in the wall
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi PAC ES Pinguino at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi PAC ES Pinguino in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 58.63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info