the “hour” and “min” buttons until the display shows:
Time Override
If you wish to operate the heater without timer, press the “MANUAL FUNCTION”
button. The yellow timer pilot light will go off.
To go back to timed operation press auto.
IMPORTANT
You must leave the heater plugged in and switched on at the mains socket to keep
the heaters memory programmed.
If the heater loses its electricity supply for more than 2 minutes, e.g. switched off at
the mains socket or in the event of a power failure, the heater’s programmes will be
lost, and the heater will not work until reset.
CLEANING AND MAINTENANCE
Before cleaning always switch off and remove the plug from the electrical socket.
1. To clean the unit, do not use solvents or abrasive detergents. A soft damp cloth
should be used to clean the surfaces of the heater.
2. Periodically clean the air inlet/outlet grilles, using a vacuum cleaner.
WARNINGS
- As with any electrical apppliance, whilst the instructions aim to cover as many eventuali-
ties as possible, caution and common sense should be applied when operating your hea-
ter, particularly in the vicinity of young children.
- Do not use the appliance in bathrooms or in the vicinity of showers, bath tubs, wash
basins, swimming pools, etc.
- Always use the heater in an upright position.
- Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (danger
of overheating).
- The heater must be positioned at least 50 cm from furniture or other objects.
- When the appliance is used in portable version, do not place it up against walls, furnitu-
re, curtains, etc.
- If the power cable is damaged, it must be replaced by the manufactured or an authori-
zed technical service centre.
- The appliance must not be positioned directly underneath a fixed power point.
- Do not cover the appliance while it is functioning in order to avoid overheating with the atten-
dant risk of fire.
- Do not use the appliance in rooms less than 4 m
2
in area.
- The use of an extension lead is not reccommended, as overheating of the exten-
sion lead may occur during the operation of the heater.
The heater is fitted with a safety device which will switch off the heater in case of acci-
dental overheating (eg. obstruction of air intake and outlet grilles, motor turning slowly or
not at all). An acoustic signal warns of any problems. To reset, disconnect the plug from the
power for a few minutes, remove the cause of overheating then plug the appliance in again.
6
5714005700/06.01
