Anti-freeze function
Turn the thermostat knob to the anti-freeze position .
When the fan heater has been set in this way it will automatically come on whenever the tempe-
rature in the room falls close to five degrees and the room wil thus remain at a temperature of a
few degrees above zero.
Summer use (ventilation only)
Turn the knob clockwise to the position, "summer service" (ventilation only) (fig. 5).
The fan only will be switched on when the fan heater has been set in this way.
Turning off the Appliance
In order to turn the appliance off, turn the function and thermostat selector knob to position "O"
(fig. 5). If the appliance is not used for long periods it is advisable to disconnect the plug from the
power socket.
Drying Function
• Pull release slider 1 (fig. 1) and move the arm to the horizontal position ready for use.
• Hang the hand-towels or the linen on the arm to dry.
• Turn the function selector knob to position 1 (1000W). It is advisable to use only this power
setting in order to dry hand-towels or other linen, particularly if they are of delicate material.
• When the appliance is not used for the drying function, the arm may be moved to rest posi-
tion by pulling the release slider and turning it downwards.
Important
Be careful not to overload or force the hand-towel holder arm.
The appliance is equipped with a special arm release device (if the latter is overloaded) which
makes it automatically drop to the vertical rest position.
MAINTENANCE
• Always check that the plug has been removed from the mains socket before carrying out any
operations on the fan heater.
• Clean the air intake and outlet grilles with a vacuum cleaner at regular frequent intervals.
• Do not use abrasive powders or solvents.
WARNINGS
• The unit must not be positioned immediately below a fixed power socket.
•
A safety device switches the fan heater off if it accidentally overheats. To reset the unit for
normal operation, remove the plug from the mains socket for a few minutes, eliminate the
cause of the overheating (e.g. air intake or outlet grilles obstructed) and then plug the fan
heater back in again. Contact your nearest Technical Assistance Service if the fan heater
does not start operating normally again.
• Never direct the fan heater's air flow towards furniture, curtains, spray cans and inflammable
material.
• If you need to replace the power supply cable, only ever use H05VV-F type cable with a cross-
section area of 2x1 mm
2
.
•
Never cover the appliance while it is operting, to avoid any risk of fire.
5
HBM 12 31-01-2001 13:56 Pagina 5
