Manual DeLonghi ECP 33.21 (page 4 of 8) (English)

634638

Zoom out

Zoom in

1/8

3. Attach the lter holder onto the machine without lling it

with ground coee (g. 6).

4. Place a 0.5 litre container under the boiler outlet and an-

other 0.5 litre container under the cappuccino maker.

5. Wait until the OK light comes on (g. 8) and immediately

afterwards turn the mode selector dial to the

position (g. 9) and deliver about half the tank through the

lter holder.

6. Then turn the steam dial to the position (g. 10)

and deliver all the water remaining in the tank through the

cappuccino maker.

7. Turn the steam dial back to the 0 position and the mode

selector dial to the l position (STAND-BY).

8. Empty the two containers and replace them under the

boiler outlet and the cappuccino maker and repeat points

5-6-7.

Now the appliance is ready for use.

Auto-o

If the appliance is not used for a certain period of time (variable

according to the model), it turns o automatically (the power

light goes out).

Tips for a hotter coee

To make espresso coee at the right temperature, the coee

maker should be preheated as follows:

1. Turn the appliance on by pressing the ON/OFF switch (the

ON light comes on) (g. 4) and attach the lter holder to

the appliance without adding pre-ground coee (g. 6).

2. Place a cup under the lter holder. Use the same cup as will

be used to prepare the coee in order to preheat it.

3. Wait until the OK light comes on (g. 8) and immediately

afterwards turn the selector dial to the position

(g. 9) and let water discharge until the OK light turns o,

then interrupt by turning the dial to the I position.

4. Empty the cup, wait until the OK light comes on again and

then repeat the same operation.

(It is normal for a small and harmless pu of steam to be given

o when removing the lter holder).

Mugs or glasses tray (models ECP35.31 and

ECP33.21 only)

If you are using tall cups or glasses (for example, to make long

coee or macchiato),extract the drip tray and rest the cup di-

rectly on the mugs or glasses tray (A14 - g. 11).

Once you have made your coee, put the drip tray back in

position.

HOW TO MAKE ESPRESSO COFFEE USING PRE

GROUND COFFEE

Important: Everytime you switch on the appliance, make sure that the

mode selector dial (B1) is turned to I position (Stand-by).

1. Place the ground coee lter (C2 or C3) in the lter holder.

Use the lter to make one coee or the

lter to make two coees.

2. To make just one coee, place one level measure of pre-

ground coee (about 7 g) in the lter. (g. 12).

To make two coees, place two loosely lled measures

(about 6+6 g) of pre-ground coee in the lter.

Fill the lter a little at a time to prevent the pre-ground

coee from overowing.

Important: For correct operation, before lling with pre-ground coee,

make sure there are no coee residues left in the lter from the last time you made

coee.

3. Distribute the pre-ground coee evenly and press light-

ly with the presser (g. 13). Correct pressing of the pre-

ground coee is essential to obtain a good espresso. If

pressing is excessive, coee delivery will be slow and the

froth will be dark. If pressing is too light, coee delivery

will be too rapid and the froth will be skimpy and light

coloured.

4. Remove any excess coee from the rim of the lter holder

and attach to the appliance. Turn the handle rmly to-

wards the right (g. 6) to avoid water leaking out.

5. Place the cup or cups under the lter holder spouts (g.

14). You are recommended to warm the cups before mak-

ing coee by rinsing them with a little hot water.

6. Make sure the OK light (g. 8) is on (if o, wait until

it comes on), then turn the mode selector dial to the

position. When the desired amount of coee

has been delivered, turn the dial to the l position.

7. To remove the lter holder, turn the handle from right to

left.

Danger of burns! To avoid splashes, never remove the lter holder while

the appliance is delivering coee.

8. To turn the appliance o, press the ON/OFF button.

HOW TO PREPARE ESPRESSO COFFEE USING PODS

1. Preheat the appliance as described in the section “Tips for

a hotter coee”, making sure the lter holder is attached.

This obtains a hotter coee.

Please note: Use pods conforming to the ESE standard, indicated on the

pack by the following symbol.

The ESE standard is a system accepted by leading pod producers and enables espresso

coee to be prepared simply and cleanly.

2. Place the pod coee lter (C4 ) in the lter holder.

3. Insert the pod, centring it as far as possible on the lter

(g. 15). Always follow the instructions on the pod pack to

position the pod on the lter correctly.

4. Attach the lter holder to the appliance. Always turn as far

as it will go (g. 6).

5. Proceed as in points 5, 6 and 7 in the previous section.

HOW TO PREPARE CAPPUCCINO COFFEE

Important: Everytime you switch on the appliance, make sure that the

mode selector dial (B1) is turned to I position (Stand-by).

1. Prepare the espresso coees as described in the previous

sections, using suciently large cups.

2. Turn the selector to the position (g. 16) and wait

until the OK light comes on.

3. In the meantime, ll a recipient with about 100 grams of

milk for each cappuccino to be prepared.

The milk must be at refrigerator temperature (not hot!).

In choosing the size of the recipient, bear in mind that the

milk doubles or triples in volume (g. 17).

Please note: You are recommended to use semi-skimmed milk at

refrigerator temperature.

4. ECP 35.31 only: Make sure the cappuccino maker selection

ring (A10) is in the “CAPPUCCINO” position (g. 18).

5. Place the recipient containing the milk under the cappucci-

no maker.

6. Wait until the OK light comes on. This indicates that

the boiler has reached the ideal temperature for steam

production.

7. Open the steam by turning the steam selector to the

position for a few seconds to eliminate any water

in the circuit. Close the steam.

8. Immerse the cappuccino maker in the milk for about 5 mm

(g. 19) and turn the steam dial to the position.

The milk now starts to increase in volume and take on a

creamy appearance.

9. When the milk has doubled in volume, immerse the cap-

puccino maker deeply and continue heating the milk.

When the required temperature (the ideal is 60°C) is

reached, interrupt steam delivery by turning the steam

dial to the 0 position and the mode selector dial to the l

position.

10. Pour the frothed milk into the cups containing the coee

prepared previously. The cappuccino is ready. Sweeten to

taste and if desired, sprinkle the froth with a little cocoa

powder.

Please note:

• To prepare more than one cappuccino, rst make all the coees then at the end

prepare the frothed milk for all the cappuccinos.

• To make coee again after the milk has been frothed, rst cool the boiler, or the

coee will be burnt. To cool it, place a container under the boiler outlet, turn

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi ECP 33.21 in the language / languages: English as an attachment in your email.

The manual is 1,12 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi ECP 33.21

DeLonghi ECP 33.21 User Manual - German - 8 pages

DeLonghi ECP 33.21 User Manual - Dutch - 8 pages

DeLonghi ECP 33.21 Quick start guide - All languages - 22 pages

DeLonghi ECP 33.21 Quick start guide - All languages - 6 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

DeLonghi ECP 33.21 Manual

Product: