562647

DeLonghi ECO 310 - ICONA Manual

4
Zoom out
Zoom in
Previous page
1/6
Next page
15
Nota Bene:
• if more than one cappuccino is to be prepared, rst
make all of the coffees and then prepare the milk for
all of the cappuccinos;
• if more coffee must be prepared after the milk has
been frothed, allow the boiler to cool first otherwise
the coffee will be burned.
To cool it, position a container under the filter-
holder spouts (fig. 11), press the steam button and
allow water to run out until the steam function light
switches off: then prepare the coffee.
Maximum steam delivery of 60 seconds is recom-
mended and the milk must not be frothed more
than 3 times consecutively.
Attention: the cappuccino maker must always be
washed after use to ensure hygiene.
Proceed as follows:
1. Discharge a small amount of steam for a few sec-
onds (see points 2,5 and 6 of the previous para-
graph) by turning the steam knob (fig. 18). By do-
ing this, the cappuccino maker empties any milk
left inside. Switch the machine off by pressing the
ON/OFF button.
2. Use one hand to hold the cappuccino tube and the
other to release the cappuccino maker by turning it
clockwise and pulling it downwards (fig. 19).
3. Remove the steam nozzle from the tube by pulling
it downwards (fig. 20).
4. Wash the cappuccino maker and steam nozzle thor-
oughly in warm water.
5. Make sure that the two holes indicated by the ar-
rows in fig. 21 are not blocked. Clean using a pin if
necessary.
6. Re-mount the steam nozzle by inserting it rmly
upwards into the steam tube.
7. Re-mount the cappuccino maker by inserting it up-
wards and turning it anti-clockwise.
PRODUCTION OF HOT WATER
1. Switch the machine on by pressing the on/off but-
ton (fig. 4). Wait for the OK light to switch on (fig.
6).
2. Position a container under the cappuccino maker.
3. Press the coffee button (fig. 7) and turn the steam
knob anti-clockwise at the same time (fig. 18): the
hot water will escape from the cappuccino maker.
4. To interrupt the hot water, turn the steam knob
clockwise and press the coffee button again (fig.
7).
Maximum delivery of 60 seconds is recommend-
ed.
CLEANING
Danger! Before performing any cleaning opera-
tions of the external parts of the appliance, switch
the machine off, remove the plug from the socket
and let the machine cool down.
Cleaning and maintenance of the filter
Clean the filter-holder and ground coffee filters about
every 300 coffees and, however, when the coffee drips
through the filter-holder and does not flow completely:
• Remove the lter from the lter-holder.
• Unscrew the lter cap (g. 22) in the direction indi-
cated by the arrow on the cap itself.
• Slide the cream enhancer device from the container
by pushing it from the cap end.
• Remove the gasket.
• Rinse all components and clean the metal lter thor-
oughly using hot water and a brush (fig. 23). Check
that the holes in the metal lter are not blocked. If
this is not the case, clean them using a pin (see fig.
24).
• Re-mount the lter and the gasket on the plastic
disc as indicated in gure 25. Make sure that the
plastic disc pin is inserted inside the hole in the
gasket as indicated by the arrow in fig. 25.
• Re-insert the unit obtained into the steel container
for the filter (fig. 26), making sure that the pin is in-
serted into the hole of the support itself (see arrow
fig. 26).
• Finally, tighten the tap.
The warranty is not valid if the cleaning operations de-
scribed above are not performed on a regular basis.
Cleaning the boiler outlet
About every 300 coffees the espresso boiler outlet must
be cleaned as follows:
• Make sure that the coffee machine is not hot and
the plug is disconnected from the socket;
• Use a screwdriver to remove the screw that xes
the espresso boiler outlet (fig. 27);
• Remove the boiler outlet;
• Clean the boiler using a damp cloth (g. 27);10
• Clean the outlet thoroughly using hot water and a
brush. Check that the holes are not blocked. If this
is not the case, clean them using a pin (fig. 24).
• Rinse the outlet under the tap, rubbing continu-
ously.
• Re-mount the boiler outlet, paying attention to po-
sition it correctly on the gasket.
The warranty is not valid if the cleaning operations de-
scribed above are not performed on a regular basis.
Other cleaning operations
1. Do not use solvents or abrasive detergents to clean
the machine. Use a soft, damp cloth.
2. Clean the filter-holder cup, the filters, drip tray and
water tank regularly.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi ECO 310 - ICONA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi ECO 310 - ICONA in the language / languages: English as an attachment in your email.

The manual is 0,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi ECO 310 - ICONA

DeLonghi ECO 310 - ICONA User Manual - German - 6 pages

DeLonghi ECO 310 - ICONA User Manual - Dutch - 6 pages

DeLonghi ECO 310 - ICONA Quick start guide - All languages - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info