770018
3
Zoom out
Zoom in
Previous page
1/13
Next page
8
3.2 Installing the appliance
Important!
When you install the appliance, you should respect the follow-
ing safety warnings:
The appliance gives o heat. After positioning the appli-
ance on the worktop, leave a space of at least 3 cm be-
tween the surfaces of the appliance and the side and rear
walls and at least 15 cm above the coee maker.
Do not place the appliance near taps or sinks. Water pene-
trating the appliance could cause damage.
The appliance could be damaged if the water it contains
freezes. Do not install the appliance in a room where the
temperature could drop below freezing point.
Arrange the power cord (A10) in such a way that it cannot
be damaged by sharp edges or contact with hot surfaces
(e.g. electric hot plates).
3.3 Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to that
indicated on the rating plate on the bottom of the appliance.
Connect the appliance to an eciently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
3.4 Setting up the appliance
Please note:
Coee has been used to factory test the appliance and it
is therefore completely normal for there to be traces of
coee in the mill. The machine is, however, guaranteed to
be new.
You should customise water hardness as soon as possible
following the instructions in section “18. Setting water
hardness”.
Proceed as described:
1. Plug the appliance into the mains socket and make sure
the main switch (A6) on the back of the appliance is in the
I position (g. 1).
2. The light ashes on the control panel (B). Remove
the water tank (A7) (g. 2), ll to the MAX line with fresh
water (g. 3A) then put back in the appliance (g. 3B).
3. The button (B4) (g. 4) ashes on the control panel.
4. Place a container with a minimum capacity of 100 ml
under the cappuccino maker (A18) (g. 5).
5. Turn the steam/hot water dial (A21) to the "I" position (g.
6). The beverage buttons ash and water is delivered from
the cappuccino maker.
6. When delivery stops automatically, turn the steam dial
back to the "O" position.
The appliance goes o.
To use it, press the button (B7) (g. 7).
Please note:
The rst time you use the appliance, you need to make 4-5
cups of coee before the appliance starts to give satisfac-
tory results.
To enjoy your coee even more and improve the perfor-
mance of your appliance, we recommend installing a water
softener lter (C4) as described in section “10. Water sof-
tener lter”. If your model is not provided with a lter, you
can request one from De'Longhi Customer Services.
4. TURNING THE APPLIANCE ON
Please note:
Before turning the appliance on, make sure the main
switch (A6) on the back of the appliance is in the I position
(g. 1).
Make sure the steam/hot water dial (A21) is in the 0
position.
Each time the appliance is turned on, it performs an auto-
matic preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this
cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
(A11) and is collected in the drip tray (A14) underneath. Take
care to avoid contact with splashes of hot water.
To turn the appliance on, press the button (B7) (g.
7). The coee” buttons (B2), (B3), (B8) and (B9) ash on
the control panel (B) to indicate the appliance is heating
up.
While heating up, the machine performs a rinse cycle. As well
as heating the boiler, this also heats the internal circuits by cir-
culating hot water.
The appliance is at temperature when the coee buttons on the
control panel remain on steadily.
5. TURNING THE APPLIANCE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts
(A11). Take care to avoid contact with splashes of hot water.
To turn the appliance o, press the button (B7) (g.
7);
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi ECAM230.13 - Magnifica S Smart at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi ECAM230.13 - Magnifica S Smart in the language / languages: English as an attachment in your email.

The manual is 5.92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi ECAM230.13 - Magnifica S Smart

DeLonghi ECAM230.13 - Magnifica S Smart User Manual - German - 15 pages

DeLonghi ECAM230.13 - Magnifica S Smart User Manual - Dutch - 15 pages

DeLonghi ECAM230.13 - Magnifica S Smart User Manual - French - 15 pages

DeLonghi ECAM230.13 - Magnifica S Smart User Manual - Italian - 15 pages

DeLonghi ECAM230.13 - Magnifica S Smart User Manual - Spanish - 15 pages

DeLonghi ECAM230.13 - Magnifica S Smart Additional guide - All languages - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info