481717
49
Zoom out
Zoom in
Previous page
1/76
Next page
48
De Dietrich Gas 310/610 ECO
11.3 Display of value
The display has only two digits available therefore values over this are displayed as followed:
Values from 00 to 99 will be indicated without any decimals points.
Values from 100 to 199 will be indicated by a dot between both digits e.g.
 =100, =110, =199
Values from 200 to 299 will be indicated by a dot behind every digit e.g. = for 200, =210, =299
Value over 300 will be indicated by showing the thousands, hundreds, tens and units in separate
alternating pairs. (see section 12.2 and 12.5)
Negative values (for instance when using an external sensor or when sensors are not connected) will be
indicated by a dot behind the last digit, e.g.  indicates -10.
12.0 OPERATING MODE
12.1 Operating mode ()
During normal operation the code-display show the status (position in cycle) of the boiler, with the -display
indicating the actual flow temperature.
The digits or letters in the code-display have the following meaning:
Code
Description

Standby, there is no heat demand

Pre-ventilation (pre-purge time 30 seconds, post purge time 3 seconds)

Trial for ignition

Burner firing and flame detected

N/a

Waiting mode, startup check, air sensor LDs sufficient pressure

Control stop (burner off + post purge)
a) Flow temperature T1 > set pointF [+5°C]
b) Flow temperature T1 > desired set point modulating control 9°F [+5°C]
c) flow temperature T1 > parameter
d) Difference flow T1 and return T2 > 10°C (factory setting) Starting condition is ≤ 10°C

End of heating demand, pump post purge. During cycling prevention delay-time the boiler will
remain in state and will not react to heat demand.

N/a

Shut-off mode (see section 12.4)

Forced full load (HIGH)

Forced part load (LOW)

Gas leakage control

Burner cooling
Table 08
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich Gas 310 ECO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich Gas 310 ECO in the language / languages: English as an attachment in your email.

The manual is 3,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info