481679

De Dietrich DHD789X Manual

29
Zoom out
Zoom in
Previous page
1/148
Next page
9
2/ INSTALLING THE HOOD
EN
- During installation, or in the case of repairs, the appliance must be unplugged.
- Make sure that the electrical tension of the power source corresponds to the electrical tension in-
dicated on the information plate on the inside of the hood.
-If you need to modify the electrical layout of your house in order to be able to use the hood, call a
qualified technician.
- Never hook up the appliance to a discharge conduit used for combustion fumes (boilers, chimneys,
etc.) or a CMV unit (Controlled Mechanical Ventilation).
- The discharge conduit, whatever it may be, must never exit into the attic.
- Install the hood at a safe distance of at least 70 cm from the hob surface, whether they are electric,
gas, or mixed.
If you have an outlet to the outside:
Air exhaust to the outside is made possible by installing a separate DHK7000 motor (sold separately).
The hood needs to be connected to the separate DHK7000 motor using a tube with a diameter of at
least 1 mm. The tube should be flexible, in aluminium and non flammable. The tube must never
have a diameter of less than 1 mm. THIS HOOD IS NOT DESIGNED TO OPERATE IN RECIRCULATION
MODE.
ELECTRIAL HOOK UP
When you install the appliance and carry out maintenance, it must be unplugged from the
power source or the fuses must be disengaged or removed. Electrical hook up must be carried
out before the appliance is installed in the cabinet.
Check that:
- the power source is sufficient,
- power cords are in good condition,
- The diameter of the cables conforms to installation regulations.
- MOUNTING THE HOOD
Installation must conform to the regulations in force regarding the ventilation of
enclosed environments. In France, these regulations are container in the DTU 61.1 of the
CSTB. In particular, discharged air must not be channelled into a conduit used for exhaust
discharge or discharge from devices that operate with gas or other combustible materi-
als. The use of unused conduits is not permissible without the approval of a qualified
technician. The minimum distance between the hob surface and the lowest part of the
hood must be 70 cm. If the instructions for the cooker installed under the hood require
an even greater distance, this must take precedence.
- INSTALLATION
To prevent any damage to the appliance, remove the grease filters before installation. To
remove the grease filters, push the handle down towards the bottom of the hood and turn the
filter downwards, removing it from its seat at the same time (Fig. A).
Important: the installation process requires at least two people.
Before installing the hood, make sure that there is a nearby mains electricity point, position
the external controller and prepare the exhaust outlet opening.
Fix the extensions (Fig. , part A) to the top plate (Fig. ) using the screws provided. Position
the top plate (Fig..1) on the ceiling; make  holes (8 mm) as shown in the template.
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich DHD789X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich DHD789X in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 1,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info