585987
17
Zoom out
Zoom in
Previous page
1/20
Next page
Rhino™ 10 Installation Manual
Connecting a Scanner
Connecting a Tethered Scanner
You can attach a tethered scanner to one of the serial or USB ports on the Rhino™ 10. Be sure to order your scanner
with the appropriate cable.
USB Scanner
1. Loosen the screws on the USB retainer and move the retainer away from the USB connector.
2. Plug the cable into one of the USB ports. Depending on the scanner you are attaching, you may hear a series
of beeps and the Good Read light may flash.
3. Slide the USB retainer toward the connector until it is firmly against the USB connector. Tighten the two
screws.
Figure 13 – USB Retainer Clip
Serial Scanner
1. The serial ports can supply either 5V or 12V power on pin 9 of the connector. The factory default is 5V
on COM1 and COM2. Verify which voltage the scanner requires.
2. If necessary, attach the cable to the tethered scanner.
3. Attach the scanner RS-232 cable to one of the COM connectors on the Rhino™ 10. Depending on the
scanner you are attaching, you may hear a series of beeps and the Good Read light may flash. Tighten
the screws to make sure the cable stays attached during use.
4. See the Users guide to configure the serial ports to work with the scanner.
Changing Serial Port Voltage
You can change the voltage available on the serial ports to supply no power, +5 VDC, or +12 VDC up to a maximum of
one amp total. The voltage selection jumpers are located under the top right cover.
This operation requires an ESD protected workstation!
Failure to pre
vent ESD damage may void the warranty. If in doubt, have an authorized Datalogic Partner
perform this installation for you.
To change the serial port voltage
13
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Datalogic Rhino 10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Datalogic Rhino 10 in the language / languages: English as an attachment in your email.

The manual is 0,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Datalogic Rhino 10

Datalogic Rhino 10 User Manual - English - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info